BROSA Aria Accent Chair User manual

ASSEMBLY GUIDE
Aria Accent Chair
v1.0

Components
Upon unpacking your chair from it’s delivery box, you should have one single
component (the body of the chair). Additional components are packed inside
the body, you will learn how to access and utilise these components in the
next steps.
Turn the chair body so that the underside is facing you. Lift the fabric of the
base of the chair to reveal the hidden compartment where the counterparts
of the chair are hidden. Remove the parts and leave the hidden compartment
open as you need access for assembly.
Chair body x 1
Unpacking
B x 2 (Back Leg)
C x 8 (Bolt)
D x 8 (Washer)
E x 1 (Allen Key)
A x 2 (Front Leg)

Step 1
D x 8
C x 8
B x 2
A x 2
E x 1
Starting with the front legs, insert a leg (A) into the
corresponding slot. Fit a washer (D) to a bolt (C) and
t it into one of the screw holes. Repeat for the second
screw to t the leg into the frame of the chair. Turn
the bolt with the allen key (F) until it is secure but do
not tighten yet. Repeat for all four legs.
Step 2 Lift the chair o the ground and turn it right side up
while being careful not to put any pressure on the
legs while you turn the chair.
A
BE
C
D

E x 1
Step 3 Place the chair on a at surface, then sit on the chair
and shift your weight around until the legs are level
and the chair does not rock. en use the allen key
(E) to tighten all the bolts.
Turn the chair upside down one last time and pull
the material cover to conceal the underside of the
chair and secure it back into its original place.
Lift the chair and place it on its legs and now enjoy
your new chair!
Step 4