BROSA Bristol Bedside Table User manual

ASSEMBLY GUIDE
Bristol Bedside Table
v1.0

Components
Upon unpacking your table from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new table.
Leg
Body
Leg
Side Beam
Side Beam
A x 8
(Ø8x30)
H x 4E x 4
(Ø15xH15)
D x 4
(Ø7xL48)
F x 4
B x 4
(Ø7xL30)
C x 4
(Ø15xH12)
G x 1
(10g)
Hardware
What you need

Step 1
1.1 Insert cam locks (E) into the corresponding holes
on the side beams making sure the mouth is facing
the screw hole.
1.2 Insert dowels (A) into the outer holes of the legs. It
is optional to use the glue over the wooden dowels.
1.3 Insert cam screws (D) into the inner holes of the
legs.
1.4 Align the the legs with the side beams using the
dowels and cam screws. Firmly press them together.
1.5 Screw the cam locks using a screw driver.
1.6 Insert plastic caps (H) to cover the cam lock holes
on the sides of the leg structure.
A x 4
D x 4
E x 4
A
E
H
D
Step 1.2
Step 1.1
Step 1.3
Step 1.4
Step 1.6
Step 1.4
H x 4
Step 1.5

5.1 Insert dowels (A) into the corresponding holes of
the table body.
5.2 Insert cam screws (B) into the corresponding
holes of the table body.
5.3 Align the the table body with the leg structure and
rmly press them together.
5.4 Insert cam locks (C) into the corresponding holes
on the leg structure making sure the mouth is facing
the cam screw. Screw the cam locks using a screw
driver.
5.5 Insert plastic caps (F) into the corresponding
holes on the sides of the leg structure.
A x 4
B x 4
C x 4
F x 4
Step 2
B
A
F
C
Step 5.1
Step 5.2
Step 5.3
Step 5.4
Step 5.5

Step 3
Gently lift the storage and place upright on a level
surface. Enjoy your new bedside table!