BROSA Hans Entertainment Unit User manual

ASSEMBLY GUIDE
Hans Entertainment Unit
v1.0

Components
Upon unpacking your storage from it’s delivery box, you should have the
separate pieces shown below. Follow the steps on the next pages to assemble
your new storage.
A x 4
(Cross Dowel)
B x 4
(Threaded Bolt)
C x 4
(Washer)
D x 4
(Lock Washer)
E x 4
(Hex Nut)
G x 4
(Shelf Support)
aa x 2
(Mounting Plate)
bb x 1
(Nylon Strap)
cc x 2
(Screw)
F x 1
(Spanner)
Hardware
Leg x 4
Central
Leg x 1
Shelf x 1
Body x 1
1
3
2
4
What you need

Step 1 Insert the cross dowel (A) into the top hole of the leg
so that the side marker faces the bolt hole. Repeat
for all four legs.
Step 2 Screw the threaded bolt (B) into the corner hole.
Repeat for all four legs.
A x 4
B x 4
A
BB

Step 3 Place the storage body (1) on on it’s back. Insert a
leg construction formed in previous steps (2) into a
corner opening. Fit a washer (C), a lock washer (D)
then a hex nut (E) to the threaded bold and tighten
with the spanner (F). Repeat for the remaining legs.
Screw central leg (3) onto the metal plate. Continue
to tighten until it’s securely fastened.
With help of the assistant, carefully stand the unit
uptight.
C x 4
D x 4
E x 4
F x 1
B
C
D
E
F
4
1
2
2
2
3
2

Step 4 Insert shelf supports (J) into the holes of the storage
compartment. Make sure that all supports are on the
same level. Insert the shelf (4) into the opening.
Lower the shelf until it rests securely on all four
supports.
J x 4
J
4
G