BROSA Theron Daybed User manual

ASSEMBLY GUIDE
eron Daybed
v1.0

Components
Upon unpacking your daybed from it’s delivery box, you should have one
single component (the body of the daybed). Additional components are
packed inside the body, you will learn how to access and utilise these
components in the next steps.
Daybed body x 1
Turn the daybed body so that the underside is facing you. Remove the cover
from the base of the daybed to reveal a hidden compartment where you’ll
nd the rest of the parts of the daybed. Take these out and leave the cover o
as you need access to the underside of the daybed to t the legs.
Unpacking
A x 4 (Leg)
B x 8 (Bolt)
C x 8 (Flat Washer)
D x 1 (Allen Key)

Step 1 Insert a leg (A) into a slot. Fit a washer (C) to a bolt
(B) and screw it into one of the holes. Repeat for the
second bolt (B) to t the leg into the frame of the
daybed. Turn the bolt (B) with the allen key (D) until
it is secure but do not tighten yet. Repeat for all of
the remaining legs.
Step 2 Lift the daybed o the ground and turn it right side
up while being careful not to put any pressure on the
legs while you turn the daybed.
A x 4
B x 8
C x 8
D x 1
C B D

Step 3 Place the daybed on a at surface, then sit on the
daybed and shift your weight around until the legs
are level and the daybed does not rock. en use the
allen key (D) to tighten all the bolts and replace the
cover on the underside of the daybed body to conceal
the hidden compartment. Enjoy your new daybed!
D x 1