BROSA Kip 3 Seater Sofa Bed User manual

ASSEMBLY GUIDE
Kip 3 Seater Sofa Bed
v1.0

Components
Upon unpacking your sofa bed from it’s delivery box, you should have one
single component (the body of the sofa bed). Additional components are
packed inside the body, you will learn how to access and utilise these
components in the next steps.
C x 16 (Bolt)
B x 1 (Allen key)
Sofa body
A x 4 (Leg)
Unpacking
Follow the zip to the component compartment. Unzip the bottom fabric and
take out the additional components.
Sofa body
What you need
1
23

Step 1
A x 4
C x 16
Pull the metal bars inside the compartment upward
until they are steady and then zip the bottom fabric
back.
Step 2 Align a leg (A) to the underside of the body so that
the bolt holes are overlapping. Insert the bolt (C) into
the hole and tighten with the allen key (B). Repeat for
all four legs.
B x 1
A
B
C

Step 3
Step 4
Step 3.1 Unzip the back fabric and pull the support legs
out.
Step 3.2 Gently lift the sofa bed and place upright on a
level surface.
Align an arm (2) to the side of the body. Insert the
connector on the arm into the conncector on the body
and gently push the arm downward until it’s steady.
Repeat for the other arm (3).
Step 3.1 Step 3.2
2
3

Step 5 To change the back position from bed to sofa, rise the
back (step 5.1) then turn the supporting legs to hide
inside the compartments (step 5.2).
step 5.1
step 5.2
step 5.2
Step 6 To change the back position from sofa to bed, take
out the supporting legs (step 6.1). Push the back a
little forward (step 6.2) then put it down (step 6.3).
step 6.2
step 6.1
step 6.1
step 6.3

Step 7 Enjoy your new sofa bed!