BROSA Lola Scoop Back Dining Chair User manual

ASSEMBLY GUIDE
Lola Scoop Back Dining Chair
v1.0

Components
Upon unpacking your chair from its delivery box, you should have one single
component (the body of the chair). Additional components are packed inside
the seat, you will learn how to access and utilise these components in the
next steps.
Turn the chair seat over so that the underside is facing you. Remove the
fabric cover, which is attached by velcro, to reveal the chair legs and a bag of
hardware.
Chair body x 1
Unpacking
C x 8 (Bolt)
E x 8 (Washer)
D x 8 (Spring Washer)
F x 1 (Allen Key)
B x 2 (Back Leg)
A x 2 (Front Leg)

Starting with the front legs, insert a leg (A) into the
corresponding slot. Fit a spring washer (D) to a bolt
(C) followed by a washer (E) and t it into one of the
screw holes. Repeat for the second screw to t the leg
into the frame of the chair. Turn the bolt with the
allen key (F) until it is secure but do not tighten yet.
Repeat for all four legs. Please note that the back legs
(B) are both the same and are to only go at the back
of the chair.
Step 1
F x 1
E x 8
D x 8
C x 8
B x 2
A x 2

Step 2 Flip the chair the right way up and place it on a at
surface, then sit on the chair and shift your weight
around until the legs are level and the chair does not
rock. en use the allen key (E) to tighten all the
bolts. Replace the cover on the underside of the seat
using the velcro tabs to conceal the exposed area.
Step 3 Enjoy your new dining chair!
E x 1