Brother CT-8000 User manual

Offset Catch Tray (CT-8000)
You can install an optional offset catch tray to this printer.
Be sure to switch off the power and unplug the power cord from the AC power outlet/socket before
carrying out the operations. If you do not, you might get an electrical shock.
Installing the Offset Catch Tray
1 Turn off the printer power switch.
2 Pull out the power cord from the AC power outlet/socket
and then the printer.
3 Open the back cover by lifting the lower gray lever at the
top left corner of the back of the printer.
Do not touch any parts inside the printer.
WARNING

4 Loosen the right and left screws as shown in the
illustration to uninstall the top cover of the paper exit.
5 Insert the right and left tabs of the offset catch tray into the
holes at the top of the printer (1), and then slowly lower it
down on the top of the printer (2).
6 Secure the screws at both ends of the bottom of the offset
catch tray.

7 Pull out the tray's extension.
8 Close the back cover.
Reconnect the AC power cord to the printer.
and then the AC power outlet/socket,
Turn the printer switch back on.