• Open the safe door
• Press the reset button (This button is
located on the inside of the safe
door by the hinges)
• Enter a 3-8 digit code followed
by the [#] key
• If the lock beeps twice the code is set, if
the yellow light flashes and the
lock beeps 3 times, the code has
not been set. Try again
• Ensure that the bolts are fully retracted
(if necessary rotate the handle to
retract the bolts)
• Gently push the door shut.
Always ensure that there are no objects or
fingers in the way of the closing door
• Turn the handle until the stop
position is reached
How to program a code
• Drill holes for expansion bolts
• Turn the expansion bolts counter
clockwise to separate
• Use the expansion bolts to secure
the safe to the floor or wall
• Make sure the safe is positioned as
required and then tighten all screws
CAUTION: Only use the expansion bolts when
there is a concrete surface. Use alternative
fixings when there is a wooden surface.
How to close the safe
• Enter your 3-8 digit code followed
by the [#] key
• Rotate the handle until the bolts
are fully retracted
• Open the safe door
How to open the safe
• After 3 incorrect entries a warning beep will
sound for 20 seconds.
During this time no other code
entries can be made
• When the beeps have stopped, try again
Incorrect entry
• Remove the emergency key cover on the
front of the key pad
• Insert the emergency key into the lock. The
key will only fit into the lock in 1 position.
Do not force the key
• Turn the key clockwise then rotate the handle
until the bolts are fully retracted
• Open the safe door
• With the safe door in the open position,
press 0 twice and now press the reset button
on the hinge side of the door
• The yellow light should now be on
• Now enter your new master 3-8 digit code
followed by the [#] key
• If the lock beeps twice and the yellow light
flashes twice the code is set
• If the lock beeps 3 times and the yellow light
flashes 3 times, the code has not been set.
Please try again
How to open the safe with the
emergency key
Setting master code
Fixing method
• This safe requiries 4x AA batteries to operate
• The battery compartment is
located on the inside of the safe door
• Burton Safes recommends Duracell batteries
Battery change
Schematic drawing of case Schematic drawing of control panel
1
Bolts
2
Reset Button
3
Battery Compartment
4
Knob
5
Emergency Lock Cover
6
Green Light
7
Red Light
8
Yellow Light
9
Confirmation button
Hotel Standard
