Burtonsafes OCULTO User manual

OCULTO COMBINATION
INSTRUCTIONS

USER INSTRUCTIONS - COMBINATION LOCKING
How to open the safe
How to close the safe
• Factory default code is 20-30-40
• Align 00 with the opening index
• Turn the dial three times anti-clockwise, and then continue
until 20 lines up with the opening index
• Turn the dial twice clockwise, and then continue until 30
lines up with the opening index
• Turn the dial once anti-clockwise, and then continue until
40 lines up with the openeing index
• Turn the dial clockwise until you reach the opening position
• Turn the door clockwise and pull it up
• Turn the door anti-clockwise to close
• Turn the dial three times anti-clockwise to 00

How to change the code
When changing your code, you should never use a number
inbetween 0 and 10 for any of the digits, and never use a
number lower than 20 as the last digit.
We recommend your chosen 3-digit code is in the order of
low to high, i.e. 15-25-40.
• Follow the instructions to open the safe door, leave the
door open
• Align 00 with the changing index
• Turn the dial three times anti-clockwise, and then continue
until the first digit of your current code lines up with the
changing index, i.e. 20
• Turn the dial twice clockwise, and then continue until the
second digit of your current code lines up with the
changing index, i.e. 30
• Turn the dial once anti-clockwise, and then continue until
the last digit of your current code lines up with the
changing index, i.e. 40
• Take the changing tool included and place it in the hole
behind the door
• Turn the tool clockwise until it stops. Do not force the tool
• Align 00 with the changing index

• Turn the dial three times anti-clockwise, and then continue
until the first digit of your new code lines up with the
changing index, i.e. 15
• Turn the dial twice clockwise, and then continue until the
second digit of your new code lines up with the changing
index, i.e. 25
• Turn the dial once anti-clockwise, and then continue until
the last digit of your new code lines up with the changing
index, i.e. 40
• Turn the tool anti-clockwise until it stops, remove the tool
• Your new code is now set
How to change the code
NOTE: If you turn past a number you meant to stop on, you cannot turn back to it.
You must start the whole process from the begining.This is for both opening your safe
and changing your code

You Will Need:
• Waterproof Membrane
• Clear Silicone
• Silica Gel Bag
• Concrete Mix:
2kg Portland cement
4kg Aggregate
3kg Sand
7kg Metal Fibres
Burton Safes can supply a full installation kit for your safe which includes all of the items
shown above. Why not ask your supplying stockist for further details?
• Remove the lid and then take the door out of the safe
• Apply silicone to all the external joints of the safe, allow 24 hours for this to set
• Prepare the hole in the oor for your safe. Leave at least 8cm clearance around the safe
and 10cm below
• Mix your concrete using the ingredients listed above and in line with the cement
manufacturers instructions
• Spread 10cm of your concrete mix in the bottom of the hole
• Wrap your safe in the waterproof membrane and position inside the hole
• Spread the rest of the concrete around the safe to ground level
• Once set, cut down the membrane so it is level with the oor
• Do not use your safe until 15 days have passed to ensure all moisture has released from
the concrete mix
• Place a silica bag inside of your safe

Version 1
September
2020
Burton Safes Ltd
Brockholes Business Park
Rock Mill Road, Brockholes
Holmrth, HD9 7BN
www.burtonsafes.co.uk
[email protected]
[phone]