Canvas WELLINGTON 063-6346-2 User manual

ASSEMBLY INSTRUCTIONS
HAVING TROUBLE?
TOLL-FREE:
1-888-670-6684
IMPORTANT: Please read this manual carefully
before beginning assembly of this product.
Keep this manual for future reference.
WELLINGTON 30” (76.2 CM)
WEATHERED - OAK BATHROOM
VANITY
PRODUCT NO. 063-6346-2

We believe in the power of décor and its
ability to make up the fabric of your home.
That’s why CANVAS® collections draw
inspiration from Canadians and the way
they live.
From on-trend furniture pieces to holiday
décor and all your outdoor living essentials,
CANVAS® makes it easy to refresh your space
to reflect your unique style and the way you
live every day.
We would love to hear from you and welcome
your thoughtful feedback. Visit our website
at canadiantire.ca to tell us about your
experience, and share your photos with us
using #myCANVASstyle.
Show us how you bring CANVAS® products
to life. We can’t wait to see!

Parts List 4
Before You Begin Assembly 9
Step-by-step Guide 11
Technical Data 21
Troubleshooting 22
Caring for Your Item 22
Warranty 23
TABLE OF CONTENTS
TOOLS REQUIRED
No. 2 Cross-head Screwdriver
Tip Shown Actual Size
NOTE: Do not over-drill/
be aware of over-drilling
• Please read and understand this entire manual before attempting to assemble,
operate, or install the product.
• Any assembly or maintenance of the product must be carried out by adults only.
• Some parts may contain sharp edges. Wear protective gloves if necessary.
• To prevent damage, place all parts on a level surface during assembly. Add a
layer of protective surface if needed.
• Do not allow your children to climb or jump on furniture due to possible
accident, injury or death. A child climbing on a piece of furniture can make it
top-heavy and cause the furniture to tip over.
• Keep children and pets away during assembly.
• Repairing and replacing parts should be done by a qualified technician.
• This unit is intended for use only within the maximum weight indicated. Use
with loads heavier than the maximum weight indicated may result in instability
causing possible injury.
• Failure to follow these warnings could result in serious injury.
WARNING! TO REDUCE THE RISK OF SERIOUS INJURY,
READ THE FOLLOWING SAFETY INSTRUCTIONS BEFORE
ASSEMBLING AND USING THE PRODUCT.
2 People

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY4
PARTS LIST
ITEM DESCRIPTION THUMBNAIL QUANTITY
7Lower Back Stretcher 1
8Middle Panel 1
9Back Panel 1
10 Upper Front Stretcher 1
11 Bottom Front Stretcher 1
12 Left Door 1
13 Right Door 1
1Backsplash 1
2Vanity Top 1
3Side Panel Left 1
4Side Panel Right 1
5Upper Back Stretcher 1
6Middle Back Stretcher 1

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 5
PARTS LIST
ITEM DESCRIPTION THUMBNAIL QUANTITY
16 Drawer Right 1
18 Drawer Bottom 1
19 Drawer Stretcher 1
17 Drawer Back 1
14 Drawer Front 1
15 Drawer Left 1

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY6
EXPLODED PARTS
3
4
1
2
10
5
6
8
13
14
9
11
7
15
12
16
17
18
19

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 7
HARDWARE LIST
ITEM DESCRIPTION THUMBNAIL QUANTITY
ALarge Cam Lock 20
BLarge Cam Bolt 20
GM3.5x15 mm Screw 25
HM3.5x10 mm Screw 12
CM8x30 mm Wood Dowel 20
DHandle with Bolts 3
EM4x25 mm Screw 6
FM4x12 mm Screw 24
ISlow Close Hinge 4
JDrawer Slides 2
KLeveller 4

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY8
HARDWARE LIST
ITEM DESCRIPTION THUMBNAIL QUANTITY
LSmall Cam Lock 6
MSmall Cam Bolt 6
NGlue 1

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 9
BEFORE YOU BEGIN ASSEMBLY
MAKE SURE ALL PARTS ARE PRESENT
Compare all pieces to the parts and hardware lists, and
make sure you have all tools required for assembly.
REMOVE PACKAGING MATERIALS
Place packing materials back in the box. Do not dispose of
packaging materials until assembly is complete.
READ EACH STEP CAREFULLY
Make sure you understand each step. If you have any questions,
contact CANVAS®customer service at 1-888-670-6684 (toll free).
ASSEMBLE IN A CLEARED AREA
Place all parts from the box on the floor in front of you on a clean,
dry, level surface to protect the product as it is being built.

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY10
BEFORE YOU BEGIN ASSEMBLY
CAM LOCK SYSTEM OPERATION
NOTE: IT IS VERY IMPORTANT TO USE GLUE WITH DOWELS. EXCESS GLUE CAN
BE WIPED OFF WITH DAMP CLOTH.
Insert dowel at least half way by tapping lightly with a rubber mallet IF NECESSARY.
GLUE
X
X
1 4
3
2
HOW THE KNOCK DOWN (KD) ASSEMBLY SYSTEM WORKS
1. Screw cam bolt into the pre-drilled small holes on panel. Align the panels to be joined
so that the cam bolt goes into the pre-drilled hole on the edge of the second panel and
protrudes into the hole that will house the cam lock.
2. Insert the cam lock into pre-drilled large hole on panel. Make sure arrow on the cam
lock is pointed toward the cam bolt.
3. Once the cam bolt is connected inside cam lock, take a cross-head screwdriver and
tighten the cam lock by turning clockwise.
You are now ready to assemble the product.

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 11
STEP-BY-STEP GUIDE
15 X117 X118 X1EX4 14 X116 X1DX1
14
15
16
17
18
M
J
E
MX6
Remove preassembled bolts from handle D. Attach drawer handle D to drawer front
14, securing with previously removed bolts. Install small cam bolts Minto drawer
front 14. Set aside.
Attach drawer left 15 and drawer right 16 to drawer back 17 using M4x25mm screws
E. Insert drawer bottom 18 into drawer left 15, drawer right 16 and drawer back 17.
Note:Make sure small cam bolts Mare completely seated.
STEP 1

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY12
STEP-BY-STEP GUIDE
17 X119 X1EX2 14 X1LX6
14
19
E
L
L
H
J
JX2
STEP 2
HX6
Attach drawer front 14 and drawer stretcher 19 to drawer left 15, drawer right 16 and
drawer back 17 using M4x25mm screws Eand small cam locks L.
Attach drawer slides Jto drawer left 15 and drawer right 16 using M3.5x10mm
screws H.

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 13
STEP-BY-STEP GUIDE
4X16X18X1 3X1BX20 AX2
HX6
CX2
8
6
3
4
3
4
A
K
B C B
H
Attach middle back stretcher 6 to bottom panel 8using large cam locks A, large
cam locks Band M8x30mm wood dowels C.
Attach drawer slides Jto side panel left 3and side panel right 4using M3.5x10mm
screws H. Attach leveller Kto the base corner blocks of the vanity assembly.
Install large cam bolts Binto side panel left 3and side panel right 4. Set aside.
Note:Make sure large cam bolts Bare completely seated.
STEP 3
KX4JX2

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY14
STEP-BY-STEP GUIDE
4X15X17X1 3X18X110 X111 X1
CX18 AX18
4
3
5
10 8
7
11
A
C
Attach upper back stretcher 5, upper front stretcher 10, lower back stretcher 7,
bottom front stretcher 11 and bottom panel assembly to side panel left 3and side
panel right 4using large cam locks Aand M8x30mm wood dowels C.
STEP 4

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 15
STEP-BY-STEP GUIDE
GX25 9X1
9
G
Attach back panel 9to the back of the vanity assembly using M3.5x15mm screws G.
STEP 5

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY16
STEP-BY-STEP GUIDE
3
Insert the drawer into the assembly by pressing down the release levers on the
slide runners and sliding the drawer into the tracks of slides.
STEP 6

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 17
STEP-BY-STEP GUIDE
13 X1 12 X1
13
I
F
I
F
D
12
Attach slow close hinge Ito right door 13 and left door 12 using M4x12mm screws
F. Remove preassembled bolts from handles D. Attach drawer handles D to right
door 13 and left door 12, securing with previously removed bolts.
Attach the hinge bases of the right door 13 and left door 12 to vanity assembly,
using the pilot holes as a guide with M4x12mm screws F.
Open and close the doors to make sure they are aligned and shut correctly. If
necessary, adjust the screws for a good fit.
STEP 7
FX24 IX4DX2

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY18
STEP-BY-STEP GUIDE
Suggested way to attach vanity to wall.
(Hardware NOT Provided.)
3
STEP 8

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY 19
STEP-BY-STEP GUIDE
2X1
2
Silicone (NOT Provided.)
3
STEP 9
Apply silicone around the edges of vanity assembly to secure the vanity top 2.

WELLINGTON 30” (76.2 CM) WEATHERED-OAK BATHROOM VANITY20
STEP-BY-STEP GUIDE
1X1
1
Silicone (NOT Provided.)
3
Apply silicone around the edges of backsplash 1and attach it to vanity assembly.
STEP 10