Canyon CNS-SW51BB User manual

SMART WATCH
USER GUIDE
CNS-SW51BB

DEVICE DESCRIPTION FIGURE 1
А
Backlight (short clicking)/
Bluetooth (long clicking) button
Attention!
These watches do not have the Touch Screen technology, so all manipulations are performed
using the A, B, C, D buttons or their combinations.
В
Function scrolling
button
D
Stopwatch reset
button
С
Stopwatch start
button
Bluetooth activation
indicator
Time
Selfie function activation
indicator
Incoming messages
notification
Incoming calls
notification
Week day
Switching on/off
Press and hold buttons B and C
3

Time setting
To enable automatic setting of the time,
connect your watch to the phone via
Canyon Fit.
To make manual settings, do as follows:
Press button D and hold it till the device
switches to the `time setting mode’: the
time indicator begins to blink. By using
buttons A and C to increase or decrease
the numeric value, you can set the time.
Use button D for switching between
hours, minutes and the date display mode
(24 or 12 hours) Store your settings by
briefly clicking button B.
Date setting
To enable automatic setting of the date,
connect your watch to the phone via
Canyon Fit.
To make manual settings, do as follows:
Briefly click button B to display the
current date.
Press button D and hold it till the device
DISPLAY MODES FUNCTIONS ON THE SCREEN:
All the display modes and the principle of navigating through the menu are
shown in Fig. 2.
switches to the `date setting mode’: the date indicator begins to blink. By using buttons A and C to increase or decrease the
numeric value, you can set the date. Use button D for switching between the year, day and month.
Briefly click button B to save the current settings.
Alarm clock setting
As displayed in Figure 3, enter the `alarm clock screen’ by using button B. To set the alarm clock, press and hold button D.
Use buttons A and C to activate and set the new alarm time. Use button D for switching between hours and minutes. Press
button B to store changes.
After the alarm is activated, switch off the alarm clock by pressing any button.
Device use:
To switch on the backlight, short click button A.
To activate Bluetooth on the watch, press button A and hold it till a corresponding symbol appears on the screen.
Use button B for the navigating through the watch menu. The menu mode will change each time this button is pressed.
4

FIGURE 2.
The navigation between functions (or menu
items) is performed by pressing the B
button.
1. Main screen
2. Date in the mm.dd format
3. Pedometer. This screen displays the
number of steps made during the day. The
steps are counted by means of a special
integrated sensor, which is sensitive to arm
movements.
4. Calories. This screen displays burned
calories. Measurements are calculated by a
predefined mathematical model using the
pedometer data.
5. Distance. This screen displays the
distance travelled. Values are calculated
based on the pedometer readings using a
pre-set mathematical model.
6. Alarm clock. This screen displays the
current alarm clock time
To set the alarm clock, see the Alarm Clock
Setting Section
7. Temperature*. This screen displays the air
temperature.
8. Barometer/altimeter*. By default, this
screen displays the atmospheric pressure
(Pa); to switch to the altimeter, briefly press
button C
9. UV radiation level *. This screen displays
the current UV radiation level
*Caution!
Weather, barometer and UV radiation data
are transferred to your watch from the
phone, if the watch is connected to Canyon
Fit. Make sure that the data transfer and
GPS functions of your phone are active,
since all above parameters are dependent
on data from the Internet and GPS satellites.
The presence of various sensors in the
watch does not guarantee the accuracy of
the physical measurements and can only
serve as an approximate measure of the
stated physical variables.
These devices are not designed to give
absolute physical measurements.
DISPLAY MODES FUNCTIONS ON THE SCREEN:
1
2
3
4
56
7
8
9
5