Clarke CWB1530 User manual

ASSEMBLY INSTRUCTIONS
GC10/12
Heavy Duty Workbench
Model: CWB1530
Part No: 7637820

Safe Working Load
2
Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]
INTRODUCTION
Thank you for purchasing this CLARKE product. Before assembling the
workbench, be sure to read these instructions thoroughly. In doing so you will
ensure the safety of yourself and of others around you, and you can look
forward to the product giving you long and satisfactory service.
CONTENTS
CWB1530 (with T-bar)
4
1
2
Post
Upper End
Beam
Beam
Lower End
Long Beam
Shelf Support
Beam
Centre Support
Plastic Foot
Posts (917mm long)
A
4
Plastic Post Caps C
Plastic Feet B
Centre Support D
Long Beams (with holes) E2
4
Shelf Support Beam F
1
Lower End Beams (with holes) H
2
1
MDF Board I
Upper End Beams (without holes) G
A
E
H
G
F
D
B
300kg (top shelf)

3
Parts & Service: 020 8988 7400/E-mail:Part[email protected] or [email protected]
ASSEMBLY
The tabs of the beams will often enter the slots fully using just firm hand pressure
but if they are too tight, you may require a rubber mallet or hammer
to assist. If so, always use a cloth to
protect the product paint finish.
1. Decide how high you want the t-
bar to be, relative to the floor.
gently,•Only use the mallet to tap
ensuring the tabs of the beams
are in line with the slots in the posts.
•When using a hammer or mallet,
always strike the edge closest to
the post and protect the paint with
a cloth.
3. Repeat this again for the other
end of the assembly, making sure
that the corresponding end
beam is at the same height.
Note that the edge with the wider
flange should be installed
uppermost. (The face with open
edges should face the rear of the
unit).
FIG 2
Long Beam
Upper End
Beam
FIG 3
FIG 4
FIG 1
Slots
2. Fit the upper end beams between
two posts as shown in Fig 1.
G
A
4. Now fit the long beams to match
the upper end beams as shown
in Fig 2.
E
G
5. Fit the centre support between
the lower end beams to provide
a t-bar only as shown in Fig 3.
D
H
E
G
6. Slot the shelf support beam
between the front/rear long
beams shown in Fig 4.
F
E
Shelf Support
Beam F
Lower
Centre Support
End
Beam H
D

7. Place the MDF board on the
top shelf.
8. Fit the plastic post caps to top
of each post as shown in Fig 5.
9. Fix the plastic foot to end of
each post as in Fig 6.
SAFETY ADVICE
•Always distribute your loads evenly
where possible.
GUARANTEE
This CLARKE product is guaranteed against
faulty manufacture for a period of 12 months
from the date of purchase. Please keep your
receipt as proof of purchase. This guarantee
is invalid if the product is found to have been
abused or tampered with in any way, or not
used for its intended purpose.
Faulty goods should be returned to their place of purchase, no product can
be returned to us without prior permission.
This guarantee does not effect your statutory rights.
FIG 5
Plastic
Post
cap
Parts & Service: 0208 988 7400
E-mail: [email protected] or [email protected]
Clarke International Hemnall Street, Epping, Essex CM16 4LG
C
I
C
A
A
B
Plastic
Foot
Post
FIG 6
A
B