Clas Ohlson 922265 User manual

EnglishSvenskaNorskSuomi
Deutsch
Wooden Cube
Alarm Clock
Bordsklocka träkub med alarmfunktion
Bordklokke med alarm, trekube
Pöytäkello jossa herätys
Holzwürfel-Tischuhr mit Weckfunktion
Art.no Model
44-2516-1 922265
44-2516-2 922263
Ver. 20170127

22

2 3
English
2
Wooden Cube
Alarm Clock
Art.no 44-2516-1 Model 922265
44-2516-2 922263
Please read theentire instruction manual before using
theproduct and then save it for future reference.
We reserve theright for any errors in text or images and any
necessary changes made to technical data. In theevent
of technical problems or other queries, please contact our
Customer Services (see address details on theback).
Safety
• Theclock must only be repaired by qualified service
technicians.
• Theclock is for indoor use only.
• Do not place theclock where there is arisk of it falling
into water or other liquid.
• Do not place theclock in damp, dusty environments or
where there is anoccurrence of strong vibrations.

4
English
1
2 3 4
• Do not expose theclock to extremely high or low
temperatures. Do not expose theclock to direct sunlight.
• Never try to open, change or modify theclock in any way.
• Always remove thebatteries if theclock is not to be
used for along time.
Product description
1. Display
2. PM symbol
3. Alarm symbol
4. Temperature symbol

4 5
English
DC 5V
DOWNUPSET
5
6 7 8 9
5. Outer battery cover
6. [SET] Settings
7. [UP] Move up in menu, increase avalue
8. [DOWN] Move down in menu, decrease avalue
9. USB port

6
English
DC 5V
DOWNUPSET
DC 5V
DOWNUPSET
CR2032
10
11
12
10. Compartment
for 3×AAA/
LR03 batteries
11. Inner battery
cover
12. CR2032
battery for
time memory

6 7
English
Operating instructions
Note: For optimum operation and to preserve battery
charge, thealarm clock should be powered using theUSB
cable wherever possible.
Operation using USB cable
Connect theclock to acomputer or other USB charging
device using theincluded USB cable. Note: Acompatible
USB charger is not included but can be purchased separately.
Battery operation
1. Remove theouter battery cover (5) by lifting thetab on
thebottom edge. Lift it up and thecover will come away.
2. Insert 3×AAA/LR03 batteries into thebattery
compartment (10), observing thecorrect polarity
(see themarkings inside thebattery compartment).
3. Refit thebattery cover by first slotting in thetwo tabs
in thetop edge and then pressing down on thebottom
edge.

8
English
Setup
Time
1. Press [SET] repeatedly until
thetime setting is displayed.
2. Hold in [SET] for 2 seconds.
- Press [UP]/[DOWN] to change between 12-hour
and 24-hour clock display.
- If the12-hour clock format is chosen, thePM
symbol will be displayed in thetop left corner of
thedisplay in theafternoon.
3. Press [SET] and thehours will begin to flash.
- Press [UP]/[DOWN] to set thehours.
4. Press [SET] and theminutes will begin to flash.
- Press [UP]/[DOWN] to set theminutes.
5. Press [SET] or wait for 15 seconds and thesetting
will be saved.
Handy tip: Holding the [UP] or [DOWN] button down will
change thetime quickly.

8 9
English
Date
1. Press [SET] repeatedly until
thedate setting is displayed.
2. Hold down [SET] for 2 seconds
until theyear begins to flash.
- Press [UP ]/[ DOWN ] to set theyear.
3. Press [SET ] and themonth will begin to flash.
- Press [UP ]/[ DOWN ] to set themonth.
4. Press [SET ] and theday will begin to flash.
- Press [UP ]/[ DOWN ] to set theday.
5. Press [SET ] or wait for 15 seconds and thesetting
will be saved.
Alarm
1. There is thepossibility of setting three different times
for thealarm in theclock memory: A1, A2 and A3.
2. Press [SET ] therequired
number of times until “A1”,
“A2” or “A3” is displayed.

10
English
3. Hold down [SET] for 2 seconds and thehours will
begin to flash.
- Press [UP ]/[ DOWN ] to set thehours.
4. Press [SET ] and theminutes will begin to flash.
- Press [UP ]/[ DOWN ] to set theminutes.
5. Press [SET ] or wait for 15 seconds and thesetting
will be saved.
• Thealarm is now on and thealarm symbol will show
on thedisplay.
• Thealarm clock will emit aring signal at theset time,
thesignal will sound for 1 minute or until any of
thebuttons on theback is pressed.
• Theclock will sound thealarm at thesame time every
day unless thealarm function is switched off.
• Thealarm is switched off by pressing [SET] therequired
number of times until thealarm time in question “A1”,
“A2” or “A3” is displayed.
• Press [UP ] to toggle between −− (off) and ON (on).

10 11
English
Other functions
Display programmes
Press [UP ] to choose one of
thedisplay programmes
dp-1, dp-2 or dp-3.
Display programme 1 “dp-1”
• Thedisplay alternates between showing thetime, date
and temperature.
• Thetime is shown for 10 seconds, thedate and
temperature for 2 seconds.
Temperature
1. Theclock has abuilt-in temperature sensor and
theambient temperature can be displayed and is
updated once every minute.
2. Press [SET ] repeatedly until thetemperature setting
is displayed.
3. Hold down [DOWN] for 3 seconds to toggle between
Celsius (°C) and Fahrenheit (°F).

12
English
Display programme 2 “dp-2”
• You can choose whether thedisplay is to show
thedate, alarm or temperature.
• Select by pressing [SET ] therequired number of times.
• Your selection will be shown on thedisplay constantly.
Display programme 3 “dp-3”
• Thedisplay will show thetime, which is thestandard setting.
Power save mode on/off
Note: During battery operation thepower save mode
should always be ON.
Press [DOWN ] repeatedly to switch between power save
mode ON/OFF.
1. When “oNSd” is displayed,
thepower save mode is ON.
2. When “−−Sd” is displayed,
thepower save mode is OFF.
3. Thedisplay will switch off after 10 seconds of inactivity
and remain off until any of thesides of thecube is
touched or until thealarm sounds.

12 13
English
Time memory
Theclock has abuilt-in memory for thetime and date.
Thememory is powered by afactory-installed CR2032
battery which can be replaced if theclock no longer saves
thetime after thepower source has been disconnected.
1. Replace thebattery by unscrewing theinner battery
cover (11).
2. Remove thecover and change thebattery.
3. Refit thebattery cover and secure it with thescrew.
Care and maintenance
Clean theproduct using alightly moistened cloth.
Use only mild cleaning agents, never solvents or
corrosive chemicals.

14
English
Troubleshooting guide
Theclock does
not work on
battery power.
• Check that theAAA batteries
are not flat.
• Check for correct battery
insertion.
Theclock does
not work on
USB cable power.
• Is thecable connected correctly?
• Is power source computer
in standby mode?
• Is theUSB charger defective?
Time and date not
saved following
power removal.
• Replace theCR2032 battery for
thememory.

14 15
English
Responsible disposal
This symbol indicates that this product should
not be disposed of with general household
waste. This applies throughout theentire EU.
In order to prevent any harm to theenvironment
or health hazards caused by incorrect waste
disposal, theproduct must be handed in
for recycling so that thematerial can be disposed of in
aresponsible manner. When recycling your product, take
it to your local collection facility or contact theplace of
purchase. They will ensure that theproduct is disposed of
in anenvironmentally sound manner.
Specifications
Power supply 3×AAA/LR03 batteries or USB cable
(CR2032 battery for memory)
Time format 12 or 24 hour clock
Alarms 3
Display programmes 3
Temperature range 0–50 °C (32–122 °F)
Power save mode On/Off
Size 63×63×63mm

16 17
Svenska
Bordsklocka träkub
med alarmfunktion
Art.nr 44-2516-1 Modell 922265
44-2516-2 922263
Läs igenom hela bruksanvisningen före användning och
spara den sedan för framtida bruk. Vi reserverar oss för
ev. text- och bildfel samt ändringar av tekniska data.
Vid tekniska problem eller andra frågor, kontakta vår
kundtjänst (se adressuppgifter på baksidan).
Säkerhet
• Klockan får endast repareras av kvalificerad servicepersonal.
• Klockan är endast avsedd för inomhusbruk.
• Placera inte klockan så att den kan falla ner ivatten eller
annan vätska.
• Placera inte klockan ifuktig eller dammig miljö eller där
det förekommer starka vibrationer.
• Utsätt inte väckarklockan för extremt höga eller låga
temperaturer. Utsätt den inte heller för ihållande,
direkt solljus.

16 17
Svenska
1
2 3 4
• Försök aldrig öppna höljet eller ändra/modifiera väckar-
klockan på något sätt.
• Ta alltid ut batterierna ur väckarklockan om den inte ska
användas under enlängre period.
Produktbeskrivning
1. Display
2. PM-symbol
3. Alarmsymbol
4. Temperatursymbol

18
Svenska
DC 5V
DOWNUPSET
5
6 7 8 9
5. Batterilucka, yttre
6. [SET] Inställningar
7. [UP] Uppåt imenyn / öka ettvärde
8. [DOWN] Nedåt imenyn / minska ettvärde
9. USB-ingång

18 19
Svenska
DC 5V
DOWNUPSET
DC 5V
DOWNUPSET
CR2032
10
11
12
10. Fack för
3×AAA/
LR03-batterier
11. Batterilucka,
inre
12. CR2032-
batteri för
tidsminnet

20
Svenska
Användning
Obs! För bästa funktion och för att spara batterier,
använd drift via USB-kabel.
Drift via USB-kabel
Anslut den medföljande USB-kabeln mellan klockan och
endator eller lämplig USB-laddare. Obs! Säljs separat.
Batteridrift
1. Ta bort den yttre batteriluckan (5) genom att ta tag
iklacken vid luckans undre kant. Lyft uppåt och luckan
lossnar.
2. Sätt i3×AAA/LR03-batterier ibatterifacket (10) och
var uppmärksam på märkningen ibotten på batteri-
facket så att polariteten blir rätt.
3. Sätt tillbaka batteriluckan genom att först passa in
de två klackarna iluckans överkant och sedan trycka
nedåt iunderkant.