Connects2 CAM-3 User manual

Sensor: 1/4” (6.35mm) CMOS
Current Consumption: 106mA @ 13.8V
Resolution: (TV Lines) 480
Minimum Illumination: 0.1 Lux
Angle: 170 Degrees
Effective Pixels: 648 x 488
TV system: NTSC
Video Output: 1.0V p-p 75ohm
Parking Lines: Yes
Working Voltage: DC9-16V (Negative Ground)
Operating Temperature: -30 Degrees C to +65 Degrees C
Waterproof Rating: IP67
Infra-Red LED’s: No
Image: Mirror
Enhanced Performance In Low Light: Yes
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any tech-
nical issues. With this in mind, when contacting Connects2, try to provide as much Infor-
mation as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Rearview CMOS Camera
Pivoting, Surface Mounted (Vertical
Adjustment) with White Housing
PRODUCT FEATURES:
DISCLAIMER:
CAM-3

www.connects2.com
2
Connects2Vision
CONTENTS
- Camera with adjustable mounting bracket and 1m cable to RCA Female video
connector and Female DC connector
- 2.5m DC power cable with Male DC connector
- 6m RCA Male to Male extension cable
- Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should be con-
nected to the reversing light circuit or an interface which provides a reverse signal.
3. Select a suitable location for the camera and ensure that the area is free from all
cables, fuel & oil.
4. Whenever possible, avoid locations that are subject to road dirt & water spray.
5. Remove the protective backing from the adhesive pad and place the camera in
the required position.
6. Using the supplied video cable, connect the camera to the display screen and
ensure that the image is displayed correctly.
7. Adjustment of the camera may be required to ensure that the correct angle of
the image is achieved.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2