Connects2 CAM-58 User manual

www.c2vision-eu.com
Image Sensor: 1080P
TV Lines: 800
Resolution: 1280 x 720
Minimum Illumination: 0.1 Lux
TV System: NTSC
Waterproof Rating: IP68
Horizontal Angle: 120 Degrees
Vertical Angle: 100 Degrees
Parking Lines: Yes (Removable)
Image Adjustment: Yes (Mirror/Normal)
Enhanced Performance In Low Light: Yes
Video Output: 1.0V p-p 75ohm
Operating Voltage: 12V DC (Negative Ground)
Operating Temperature: -20 Degrees C to +70 Degrees C
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Universal 120° AHD Camera
in Flush Mount Housing (Drill to Fit)
PRODUCT FEATURES:
DISCLAIMER:
CAM-58

2
Connects2Vision
www.c2vision-eu.com
CONTENTS
• Camera with 1m cable to Female DC connector and RCA Female
connector
• 1m DC power cable with Male DC connector
• 6m Male to Male RCA extension cable
• Hole saw
• Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should
be connected to the reversing light circuit or an interface which provides a
reverse signal.
3. Select a suitable location for the camera and ensure that the area is free
from all cables, fuel & oil. Whenever possible, avoid locations that are subject
to road dirt & water spray.
4. Aim to mount the camera preferably 45-60cm from the ground and cut a
suitable hole using the cutting tool provided.
5. Using the supplied video cable, connect the camera to the display screen
and ensure that the image is displayed correctly.
NB: Rotation of the camera may be required to ensure that the correct
orientation of the image is achieved.
6. To swap the image from mirror to normal view, cut the small White looped
wire which is located on the camera connection cable.
7. To remove the parking line feature, cut the small Blue looped wire which is
located on the camera connection cable.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2