Connects2 Vision CAM-4 User manual

www.c2vision-eu.com
Image Sensor: 1/4” (6.35mm) CMOS
TV Lines: 480
Resolution: 648 x 488
Minimum Illumination: 0.1 Lux
TV System: NTSC
Waterproof Rating: IP67
Infra-Red LED’s: Yes (20-30ft)
Angle: 170 Degrees
Parking Lines: Yes
Enhanced Performance In Low Light: Yes
Video Output: 1.0V p-p 75ohm
Operating Voltage: DC9-16V (Negative Ground)
Current Consumption: 56mA @ 13.8V
Operating Temperature: -30 Degrees C to +65 Degrees C
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as much
Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Mini Rearview CMOS Camera
Pivoting, Surface Mounted with IR LEDs
(Vertical Adjustment)
PRODUCT FEATURES:
DISCLAIMER:
CAM-4

2
Connects2Vision
www.c2vision-eu.com
CONTENTS
• Camera with adjustable mounting bracket and 1m cable to RCA Female
video connector and Female DC connector
• 2.5m DC power cable with Male DC connector
• 6m RCA Male to Male extension cable
• Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should
be connected to the reversing light circuit or an interface which provides a
reverse signal.
3. Select a suitable location for the camera and ensure that the area is free
from all cables, fuel & oil. Whenever possible, avoid locations that are subject
to road dirt & water spray.
4. Remove the protective backing from the adhesive pad and place the
camera in the required position.
5. Using the supplied video cable, connect the camera to the display screen
and ensure that the image is displayed correctly.
6. Adjustment of the camera may be required to ensure that the correct angle
of the image is achieved.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2