Connects2 CAM-32 User manual

www.c2vision-eu.com
Image Sensor: 1099 HD CCD
TV Lines: 560
Resolution: 976 x 496
Minimum Illumination: 0.1 Lux
TV System: NTSC
Waterproof Rating: IP68
Viewing Angle: 135 Degrees (Horizontal) 105 Degrees (Vertical)
Electronic Shutter: NTSC 1/60S, PAL 1/50S
Enhanced Performance In Low Light: Yes
Video Output: 1.0V p-p 75ohm
Operating Voltage: 12-24V DC (Negative Ground)
Current Consumption: 138.8 mA @ 13.8V
Operating Temperature: -20 Degrees C to +75 Degrees C
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
The place of installation must be free of moisture and away from heat sources. Please
ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Universal Reverse Camera ideal for
Van/Camper Vans
PRODUCT FEATURES:
DISCLAIMER:
CAM-32

2
Connects2Vision
www.c2vision-eu.com
CONTENTS
• Camera with 30cm connection cable
• Instructions
INSTALLATION
Note: CAM-RCA1 extension cable is required for installation.
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should
be connected to the reversing light circuit or an interface which provides a
reverse signal.
3. Select a suitable location for the camera and ensure that the area is free
from all cables, fuel & oil. Whenever possible, avoid locations that are subject
to road dirt & water spray.
4. Mount the camera to the desired location and connect the CAM-RCA1
extension cable to the 30cm connection cable.
5. Connect the camera to the display screen via the Yellow RCA connector
and ensure that the image is displayed correctly.
6. Adjustment of the camera may be required to ensure that the correct
angle/orientation of the image is achieved.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2