Connects2 Connects2Vision CAM-22 User manual

Image Sensor: 1099 HD-CCD
Resolution: 976 x 496
TV Lines: 480
Horizontal Angle: 170 Degrees
Vertical Angle: 120 Degrees
Lumen: 0.1 Lux
TV System: NTSC
Video Output: 1.0V p-p 75ohm
Operating Voltage: 12V DC (Negative Ground)
Current Consumption: 120mA @ 13.8V
Waterproof Rating: IP68
Operating Temperature: -20 Degrees C to +70 Degrees C
Parking Lines: Yes
Removable Lines: Yes
Adjustable Image: Yes (Mirror/Normal
Enhanced Performance In Low Light: Yes
User Manual
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for installation.
Please ensure you use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any
technical issues. With this in mind, when contacting Connects2, try to provide as
much Information as possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com
Universal Camera
Surface Mount Metal Bracket
with Bevelled Squared Housing
PRODUCT FEATURES:
DISCLAIMER:
CAM-22

www.connects2.com
2
Connects2Vision
CONTENTS
- Camera with adjustable bracket and 1m cable to mini Male 6 pin connector
- 1m camera connection cable to mini Female 6 pin connector and RCA
Female connector
- 6m Male to Male RCA extension cable
- Instructions
INSTALLATION
1. Connect the Black wire to a suitable ground and the Red wire to a switched
+12V supply.
2. If the camera is to be used in the rear of the vehicle, the Red wire should
be connected to the reversing light circuit or an interface which provides a
reverse signal.
3. Select a suitable location for the camera and ensure that the area is free
from all cables, fuel & oil. Whenever possible, avoid locations that are subject
to road dirt & water spray.
4. Remove the protective backing from the adhesive pad and place the
camera in the required position.
5. Using the supplied video cable, connect the camera to the display screen
and ensure that the image is displayed correctly.
6. Adjustment of the camera may be required to ensure that the correct angle
of the image is achieved.
7. To swap the image from mirror to normal view, cut the small White looped
wire which is located on the camera connection cable.
8. To remove the parking line feature, cut the small Blue looped wire which is
located on the camera connection cable.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2