Courtyard Creations TGS83HS-WM User manual

PARTS LIST
PART
NO. MATERIAL CODE PART Q’TY PART
NO. MATERIAL CODE PART Q’TY
1
8
9
10
11
12
2
3
4
5
1
2
4
1
1
2
12
24
12
12
1
16
7
TABLE TOP
LEG
SUPPORT
CENTRE CONNECTOR
CENTRE
CONNECTOR WITH RING
SCREW ST4.2*12
BOLT M6*60
WASHER d6.5*D13*1.0
PLASTIC NUT M6*P1.0
BOLT CAP M6
HEX.KEY
WRENCH 6MM
NUT WRENCH 10&13MM
TGS83HS-CS01
TGS83HS-CS02
TGS83HS-CS03
17C01A0721091Y4
17FA05040301-Y4
18000C23001
18000337002
17KAA0201----Y4
17KAB1101----Y4
ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
INTENDED FOR RESIDENTIAL USE ONLY.
TGS83HS-WM
COURTYARD CREATIONS INC.
PAGE 1 OF 2
62TGS83HSY201
62TGS83HSY101
17C17A0403001Y4
Use the correct bolts as indicated. Do not tighten any of the bolts until is completely assembled.
Do not sit or stand on this table.
A weighted umbrella base must be used when using an umbrella with this table.
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed by children.
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
Quote the following FQC NO. when contacting the service center.
!
!
!
!
!
!
!
You will need the following tools:
-Phillips Screwdriver (Not Included)
-Hex.Key Wrench (See Part #11)
-Nut Wrench (See Part #12)
Step 1:
Place the table top (#1) onto a non-abrasive surface,
such as a carpet, with its underside facing upwards.
Insert the legs (#3) and the supports (#2) into the plastic
holders attached on the underside of the table top (#1)
rim. See Figure 1.
SERVICE CENTER TOLL FREE NO.
TEL: [phone]
FAX: [phone]
FIGURE 1
STOP DON’T RETURN TO STORE!

STOP DON’T RETURN TO STORE!
PAGE 2 OF 2
FIGURE 2 FIGURE 3
Cleaning and Maintenance
• Wash frame parts with mild soap and water, rinse
thoroughly, and dry completely. Do not use bleach,
acid, or other solvents on the frame parts.
• Wash glass with mild soap and water, rinse thoroughly,
and dry completely.
• Inspect and tighten all bolts and fasteners on a regular
basis to ensure proper performance and safety of your
table.
• When moving the table, remove the umbrella and lift.
Do not drag this table.
• We recommend the use of furniture covers when not
in use.
• In order to prolong the life and beauty of your table, we
recommend that it be stored in a dry and protected
area during off season periods.
• Tempered glass has been used for increased strength
and safety of your table. However, during windy
conditions the umbrella should be lowered and/or
removed.
Step 2:
Fasten the supports (#2) into the plastic holders by
using screws (#6). See Figure 2.
Step 3:
Fasten the centre connector with ring (#4) and the
centre connector (#5) to the middle of the legs (#3)
and the supports (#2) by using bolts (#7), washers
(#8) and plastic nuts (#9). Make sure that all of the
bolts have been tightened completely and cover them
with bolt caps (#10). See Figure 3.
Step 4:
Turn the table to its upright position. See Figure 4.
Note:
To use an umbrella with this table, remove the plastic
centre plug and put the umbrella pole through the
table top and centre connector ring.
FIGURE 4
The store where you made your purchase
does not stock parts for this item.
If you need parts,
whether they are missing or damaged,
STOP!
Missing A Part?
No Need To Go Back To
The Store
Call us between 9:00 AM and 4:30 PM
Eastern Time Monday through Friday
Call Toll Free:
TEL: [phone]
FAX: [phone]
READ THESE INSTRUCTIONS COMPLETELY BEFORE STARTING ASSEMBLY
SEPARATE AND IDENTIFY ALL PARTS, MAKING SURE THAT YOU
HAVE ALL OF THEPARTSLISTED.
IF YOU DO NOTLOCATE ALL OF THE PARTS LISTED, INSPECT THE
PACKING MATERIAL FOR SMALL PARTSTHAT MAYHAVEBECOME
SEPARATED DURING SHIPMENT.
IF YOU EXPERIENCEANY DIFFICULTY DURING ASSEMBLYOR IF ANY
PARTS ARE MISSING OR DAMAGED,CALL THE HELP LINE AT
1-877-539-7436BEFORERETURNING THIS ITEM TO THE STORE.
PROVIDE THEFOLLOWING INFORMATION WHEN CALLING:
1-MODEL NUMBER OF THEPRODUCT.
2-PARTNUMBER AND MATERIAL CODE OF THE PARTFROM THE PARTS
LIST.
MOST PROBLEMS CAN BERESOLVED WITHOUT RETURNING THIS
PRODUCT TO THERETAILER.