10
• The chin strap must be closed firmly for a
secure fit. It is fitted correctly if it is difficult
to slide your fingers under the chin strap.
However, you must still be able to comfortably
breathe, swallow and turn your head.
• Verify the helmet was tested according to the
latest ECE standard.
Maintenance and Care
Regular maintenance and care contributes to
safety and maintaining the helmet.
Cleaning of the Helmet
• Never use solvents, petrol or other detergents
when cleaning the shell and interior of your
helmet.
• Always use pH-neutral detergent dissolved in
clean water. Careful rub with a soft cloth. Then
wipe dry with a lint-free cloth.
Visor care and cleaning
• After using the helmet, lightly wipe off any
grime (e.g. dead insects, dirt, sand, dust etc.)
from the visor with a soft cloth and then fully
wipe it clean using a dry soft cloth.
• When the visor gets wet (e.g. rainwater) it
should always be wiped with a soft cloth.
• When cleaning the visor, never use any petro-
leum-based solvents or detergents containing
abrasives.
GB
Winter Collar
To reduce the wind inlet at the bottom of the hel-
met during periods with very cold temperatures,
the pre-installed standard collar (14) can be
replaced with the supplied winter collar (15).
Removing the standard collar
Pull the one-piece standard collar out of the
helmet (see Fig. J).
Inserting the Winter Collar
First attach the plastic clip in the centre at the
back part of the helmet in the groove between
the outer shell and the padding.
Once the plastic clip is completely locked, press
the complete winter collar again firmly onto the
padding of the helmet (see Fig. K).
Visor Replacement
If the pre-mounted visor (7) is damaged or
severely scratched, you can exchange it with the
replacement visor.
Removal of the Visor
• Slide the visor into the highest position (fully
opened) (see Fig. L).
• Pull the visor-locking lever and remove the visor
(see Fig. M).
Inserting the Visor
• Place the replacement visor on the hold-down
device and observe the correct positioning in
the process (fully opened) (see Fig. L).
• Pull the visor-locking lever and place the visor
appropriately (see Fig. N).
• Allow the replacement visor to snap in and
close the visor.
Selecting the Correct
HelmetSize
• Measure the circumference of your head and
select the helmet size based on this measure-
ment. Try out several helmets before deciding.
Ideally, the skin on your temples will move
along when wearing the helmet.
• Ensure that even without the chin strap secured,
the helmet does not move much on your head.
Size table
Size Head circumference
M 57 – 58cm
L 59 – 60cm
XL 61cm
