Degelman Landroller LRX Series User manual

LATCH & END WHEELS....Latch & End Wheel Cylinders
SWING ARM CIRCUIT..................Power-fold Cylinders
CTR WHEEL & FLOAT....Hitch & Center Wheel Cylinders
3
2
1
A
B
Connect Hydraulics
Opening into Field Position
143376 v1.1
(Refer to operators manual for complete safety and operation info.)
• Check for missing, worn or damaged parts.
• Working points & pins
• Hydraulic Connections & Hoses
• Hubs & Spindles
Maintenance
(Check Machine Daily)
QUICK-START GUIDE*
for LRX LANDROLLERS
* Refer to operators manual for complete safety and operation info.
T
O
B
E
E
L
I
G
I
B
L
E
F
O
R
Y
O
U
M
U
S
T
R
E
G
I
S
T
E
R
WARRANTY
REMEMBER! You must complete Product
Registration to be eligible for Warranty.
3
3
7
8
9
7) Remove the Red
Transport Pin from the
float hitch and secure
it in storage position.
8) Open the Hydraulic
Ball Valve.
9) Retract the Hitch Cylinder
to place the Landroller into Float Position.
3
33
66
6) Retract the Center Frame Cylinders to raise the center
frame wheels (lowering the center section to the ground).
10) The LRX Landroller should now be in the proper position
for field use. Read manual for further information.
2
4
4
2
2
4
4) Extend the Power-fold Cylinders to fully open the
wings. Ensure the swing-arm shafts properly latch into
place.
5) IMPORTANT:
Retract the
POWER-FOLD
Cylinders
Remember to retract
the Power-fold
Cylinders back into
the fully closed position
before use.
2
2
2
5
1) Drive the LRX Landroller onto an area of level ground
large enough to open the wings. Ensure the Landroller is
positioned straight behind the tractor.
2
3
1
3) Activate the End Wheel
Cylinders to completely
raise the end wheels and
lower the ends of the
drums to the ground.
1
2) Remove the four Red Transport Bars from the End Wheel
& Center Wheel cylinders. Place the transport bars onto
the frame mounted storage brackets and secure with the
lock-pins.
Note: You may need to activate (extend) the
hydraulic cylinders slightly to allow easier
removal of the cylinder Transport Bars.

CMoving Into Transport Position
2) Fully extend the Front Hitch & Center Frame Cylinders.
This places the float hitch
into Transport Position
and also fully lowers the
Center Frame Wheels
(raising the center section
off the ground).
3) IMPORTANT:
• Secure the Float Hitch
in place with the Red
Transport Pin.
• Close the Hydraulic Ball Valve.
4) Completely extend the End Wheel & Latch Cylinders to lower
the End Wheels and open the Swing-Arm Latches.
1) Drive the LRX Landroller onto an area of level ground with plenty
of room to drive straight forward.
6) Drive forward until roller wings trail straight behind tractor.
5) IMPORTANT: Ensure the POWER-FOLD
Cylinders are RETRACTED (closed)
Ensure that the Power-Fold Cylinders have been fully retracted
before moving forward. Failure to do so could damage the
Power-Fold cylinders and require replacement.
7) Install the four Red Transport Bars onto the End Wheel &
Center Wheel cylinder shafts and secure in place using the
lock-pins.
Ensure front Red Transport Pin has also been installed correctly
into the float hitch (refer to step 3).
8) Read and follow necessary safety procedures outlined in
Transport Safety section of the manual.
3
3
1
3
3
2
1
5
6
4
1
1
1
4
4
2