Degelman PRO-TILL 30 User manual

3
5
3
4
2222
4
1
1
1
1
* Refer to operators manual for complete safety and operation info.
Maintenance
(Check Machine Daily)
AConnect Hydraulics WHEELS
ROLLERS
TRANSPORT
WINGS
JACK
3
5
4
2
1
5
4
1
3
2
FLOAT
(if available)
143411 v1.1
QUICK-START GUIDE*
for PRO-TILL 30/36
* Refer to operators manual for complete safety and operation info.
T
O
B
E
E
L
I
G
I
B
L
E
F
O
R
Y
O
U
M
U
S
T
R
E
G
I
S
T
E
R
WARRANTY
REMEMBER! You must complete Product
Registration to be eligible for Warranty.
GPS Reference
(Set overlap to 6”per side)
(with 20" discs) 2" Depth
Pro-Till 30 352” (8.95m)
Pro-Till 36 431” (10.95m)
(with 20” discs) MAX Depth
Pro-Till 30 355” (9.0m)
Pro-Till 36 434” (11.0m)
(Consider setting the GPS to include
a 6”implement oset to the right)
• Hydraulic Connections/Hoses
• Working points & pins
• Hubs, Spindles, & Tire Pressure:
- End Wheels: 41 PSI (283 kPa)
- Center (confirm tire type):
389 AGRIFLEX: 40 PSI (275 kPa)
382 FLOTRUCK: 58 PSI (400 kPa)
• Check for missing, worn or
damaged parts.
*Refer to operators manual for
complete safety and operation info.
IMPORTANT: The Wing Cylinder Circuit includes a Down Pressure
Valve. Operator must engage wing circuit hydraulics constantly
in the extended direction to ensure constant down pressure.
CONSTANT
PRESSURE

Typically
Set to 2”
Rear Disc Depth Adjustment
(2 Outer Roller Frame Cylinders)
2
Front Disc Depth Adjustment
(2 End Wheel Cylinders)
1
BPut in Field Position
i)
ii)
iii)
1”
3
4
4
FMAX Transport Speed: 40 km/h (25 MPH)
ELower Wheels for Headland Turns.
1
PRO-TILL 30/36
Scraper Position Overview (Rubber Rollers)
Set Gap
distance at
1/4” to 3/8”
from roller surface.
Storage Position
Maintenance
Position
Engaged Position
Remove the 4 bolts to rotate into
or out of “Storage position”,
then re-install.
Loosen the 4 bolts to rotate up into
“Maintenance
Position”
& secure.
Loosen the 4
bolts to rotate
downward.
Set the scraper
clearance
(1/4” to 3/8”).
Properly tighten.
DTest. Check. Adjust. 10-12 MPH
100m100m
(Ideal Operating Speed)
CSet Cutting Depth
(Start with 12 stops
per cylinder, test
depth & adjust)
(IMPORTANT: Add depth
stops starting from rod end)
IMPORTANT: Re-phase and cycle oil in the Depth Control
Cylinders before use. This is especially important
after long periods of storage.
1 2
3
iv)
v)
3
3 3
3
IMPORTANT: Operator must read and understand the
tractor manual in order to place the required hydraulic
circuits into oat position or constant pressure position.
4
IMPORTANT: The Pro-Till
model shown may dier,
but the general procedure
remains the same.
(*Pro-Till 40 shown)