Degelman PRO-TILL 33/40 User manual

3
5
3
42
22
24
11 1
1
* Refer to operators manual for complete safety and operation info.
Grease Points
• Front Frame / Rockshaft Pins
• Wing Frame Pins
• Cylinder Pins
• Wing Transport Roller Pins
• Hubs & Spindles
• Working points & pins
Maintenance
(Check Machine Daily)
AConnect Hydraulics WHEELS
ROLLERS
TRANSPORT
WINGS
JACK
3
5
4
2
1
5
4
1
3
2
FLOAT
(if available)
143349 v1.4
QUICK-START GUIDE*
for PRO-TILL 33/40
* Refer to operators manual for complete safety and operation info.
T
O
B
E
E
L
I
G
I
B
L
E
F
O
R
Y
O
U
M
U
S
T
R
E
G
I
S
T
E
R
WARRANTY
REMEMBER! You must complete Product
Registration to be eligible for Warranty.
GPS Reference
(Set overlap to 6”per side)
(with 20" discs) 2" Depth
Pro-Till 33 390” (9.9m)
Pro-Till 40 470” (11.9m)
Pro-Till 40 CT 491” (12.4m)
(with 20” discs) MAX Depth
Pro-Till 33 393” (10m)
Pro-Till 40 473” (12m)
Pro-Till 40 CT 493” (12.5m)
(Consider setting the GPS to include
a 6”implement oset to the right)
-OR--OR-
IMPORTANT: Models with Wing Pressure Kit
The Wing Cylinder Circuit includes a
Down Pressure Valve. Operator must
engage wing circuit hydraulics
constantly in the extended direction
to ensure constant down pressure. 4
CONSTANT
PRESSURE
FLOAT
-OR-
Models with
Wing
Pressure Kit
Standard
Conguration
Models

BPut in Field Position
3
iv)
v)
3
3 3
3
i)
ii)
iii)
1”
3
4
4
FMAX Transport Speed: 40 km/h (25 MPH)
ELower Wheels for Headland Turns.
1
Scraper Position Overview (Rubber Rollers)
Set Gap
distance at
1/4” to 3/8”
from roller surface.
Storage Position
Maintenance
Position
Engaged Position
Remove the 4 bolts to rotate into
or out of “Storage position”,
then re-install.
Loosen the 4 bolts to rotate up into
“Maintenance
Position”
& secure.
Loosen the 4
bolts to rotate
downward.
Set the scraper
clearance
(1/4” to 3/8”).
Properly tighten.
DTest. Check. Adjust. 10-12 MPH
100m100m
(Ideal Operating Speed)
CSet Cutting Depth
Typically
Set to 2”
Typically
Set to 2”
Front Disc Depth Adjustment Rear Disc Depth Adjustment
(2 Inner Wheel Cylinders) (2 Outer Roller Frame Cylinders) 21
(Start with 12 stops
per cylinder, test
depth & adjust)
(IMPORTANT: Add depth
stops starting from rod end)
IMPORTANT: Re-phase and cycle oil in the Depth Control
Cylinders before use. This is especially important
after long periods of storage.
1 2
IMPORTANT: Operator must read and understand the tractor manual
in order to place the required hydraulic circuits into oat position or
constant pressure position.
4
-OR-
4Models that have a Wing
Pressure Kit installed
Standard Conguration