DentalEZ Aeras Star 500 Elite Handpice User manual

AERAS 500 ELITE HANDPIECE
INSTALLATION GUIDE
500 ELITE HANDPIECE
Step 1:
Confirm the regulator gauge in the Junction Box/Utility Service Center on
the floor is set to 80 psi.
Step 2:
Attach air pressure gauge (262591)
on tubing. Attach swivel on top of
the gauge and tighten.
Step 3:
Snap the handpiece onto swivel.
Step 4:
Adjust air pressure until the gauge reads 38-43 psi.
Step 5:
Remove gauge and swivel from tubing.
Step 6:
Connect just the swivel back onto the tubing and tighten with the wrench
that is provided.
Step 7:
On the delivery unit turn both the chip air and water completely off.
Step 8:
Turn water up first slightly. Then turn chip air up to achieve mist.
Step 9:
Adjust the water and chip air accordingly to achieve desired mist.
Note: If water spray is choppy, the chip air is too high.
STEP 2:
STEP 3:
STEP 6:
©2020 DENTALEZ, Inc. DENTALEZ and Star are registered trademarks
and Aeras is a trademark of DENTALEZ, Inc. DENTALEZ.COM
AIR PRESSURE GAUGE
SWIVEL
SWIVEL, AIR PRESSURE GAUGE AND TUBING
HANDPIECE
SWIVEL ISO CONNECTOR
TUBING

TROUBLESHOOTING
INCONSISTENT WATER SPRAY
Chip air may be set too high for water setting.
1. Turn chip air off completely.
2. Turn water level up.
3. Verify water exits all 3 ports of handpiece head.
Note: If water does not exit from all 3 ports, check for clogging in ports. Use clean out wire as directed in
Instructions For Use to dislodge debris. Once verified water exits all 3 ports cleanly, turn up chip air slowly
to achieve desired mist. Water and chip air can be adjusted in tandem to achieve mist.
WATER LEAKING BETWEEN HANDPIECE
AND SWIVEL (See Fig 1)
Improper seal or worn O-rings.
1. Disconnect handpiece and inspect O-rings on swivel.
2. Check for proper placement or any tears and nicks.
3. Attach handpiece onto swivel.
WATER LEAKING BETWEEN SWIVEL
AND TUBING COUPLER (See Fig 1)
The seal between the swivel and tubing may not be tightened enough.
1. Use supplied wrench to tighten swivel to tubing coupler.
2. If leaking persists, remove swivel and inspect rear seal for cracks or tears.
(See Fig 2)
WATER ONLY SPRAYS BRIEFLY
DURING INITIAL OPERATION
Chip air may be set too high and is overpowering the water.
1. Turn chip air off completely.
2. Turn water level up.
3. Verify water exits all 3 ports of handpiece head.
Note: If water does not exit from all 3 ports, check for clogging
in ports. Use clean out wire as directed in Instructions For Use
to dislodge debris.
4. Once verified water exits all 3 ports cleanly, turn up chip air slowly to achieve desired mist.
5. Water and chip air can be adjusted in tandem to achieve mist.
If you are still having issues with the water spray
or leaking please call our Technical Support staff
at (866) DTE-INFO (866- 383-4636).
DENTALEZ.COM
HANDPIECE
AND SWIVEL
SWIVEL AND
TUBING COUPLER
FIG. 1
FIG. 2
REAR SEAL
O-RINGS
066207 Rev A
500 ELITE HANDPIECE