Dogtra 200NCPT User manual

200NCPT
INTUITIVE COMPACT TRAINER
Owner's Manual
Please read this manual thoroughly before operating
the Dogtra 200NCPT training e-collar.

2
IMPORTANT SAFETY AND PRODUCT
INFORMATION
WARNING
Please read all safety and product information below
before using your Dogtra product. Failure to follow
these safety instructions could result in injury to you,
your dog and others, or it could result in damage to your
Dogtra product or other property.
PRODUCT SAFETY
Training Methods
Dogtra products may be used with a variety of training
methods. However, each dog may have a different reaction
to training methods and to Dogtra products. Closely
observe your dog when determining the right training
method to use with your Dogtra product.
Aggressive Dogs
Do not use Dogtra products with aggressive dogs as such
dogs may react adversely and cause injury to people or
other dogs. Seek the assistance of a dog-training specialist
or veterinarian when dealing with aggressive dogs.
Children
Dogtra products are not toys. Adult supervision and close
attention are necessary when Dogtra products are used by
or near children.
PRODUCT DAMAGE
Electrical Product
Your Dogtra product contains electrical components and
batteries. Do not use or keep your product near heat or
flammable sources. Such use or storage may damage your

3
product and/or cause fire, explosion, injury, or property
damage.
Medical Device Interference
Dogtra products contain electrical and magnetic
components that emit low level electromagnetic waves and
radio frequencies. These electromagnetic waves or radio
frequencies may interfere with pacemakers, defibrillators,
or other medical devices. Consult your physician or
medical device maker before using your medical device
with a Dogtra product. If you think that your Dogtra
product is interfering with your pacemaker, defibrillator,
or other medical device, stop using the Dogtra product.
Inadvertent Activation
The digital microprocessor offers thousands of unique
codes to eliminate frequency match-up with other Dogtra
e-collars. The Constant button will automatically shut
down after being held down for 12 seconds or more as a
safety feature.
UNAUTHORIZED USE
Your Dogtra product should be used only in a humane
manner to train and educate your dog. Dogtra products
are not intended for use in any other manner nor are they
intended for use with other animals or with humans.
BATTERY
Your Dogtra product contains batteries. Take care when
removing and installing batteries as your fingers may get
caught. Dispose of batteries as provided by your local
regulations. Do not disassemble, crush, heat, or otherwise
alter the battery as it may cause fire, injury or property
damage.

4
CONTENTS
AT A GLANCE .................................................................
MAIN FEATURES ............................................................
OVERVIEW ......................................................................
UNDERSTANDING YOUR TRAINING SYSTEM
1. TURNING THE 200NCPT ON/OFF .........................
2. TRANSMITTER BUTTON FUNCTION ....................
3. RECEIVER FITTING ...................................................
4. FINDING THE RIGHT STIMULATION .....................
5. MAXIMIZING THE DISTANCE .................................
6. LED INDICATOR .........................................................
7. CHARGING THE BATTERY ......................................
GENERAL TRAINING TIPS ...........................................
MAINTENANCE ...............................................................
TROUBLESHOOTING GUIDE ......................................
WARRANTY AND REPAIR INFORMATION .............
5
6
7
9
10
12
13
14
15
16
18
20
21
23

5
Auto Charger
Dogtra's auto chargers are designed for use with a 10 volt
car outlet.
European Charger
Dogtra’s European chargers are designed for use with a
230 volt AC electrical outlet.
To purchase accessories, please visit www.dogtra.com or
call customer service at [phone].
ReceiverTransmitter Battery Charger
Splitter Cable Owner's Manual
AT A GLANCE
Test Light

6
MAIN FEATURES
• ½-Mile Range
• IPX9K Military Grade Waterproof
• 100-Levels of Low to Medium Stimulation
• Safety Stimulation Level Lock
• Front-Facing Dial for One-Handed Operation
• Nick/Constant Stimulation
• HPP (High Performance Pager) Vibration
• Audible Tone
• Enhanced Contact Points

7
OVERVIEW
200NCPT
Transmitter
Antenna
Rheostat Dial
Battery Charging
Receptacle & Rubber Plug
Pager
Tone
Nick
LED Indicator
Light
Stimulation
Level Lock
Toggle Switch
Constant
On/Off Magnetic
Red Dot

8
Contact Points
Collar Strap
On/Off
Magnetic
Red Dot
Battery Charging
Receptacle &
Rubber Plug
LED Indicator
Light
200NCPT
Receiver

9
UNDERSTANDING YOUR TRAINING
SYSTEM
1. Turning the 200NCPT On/Off
To turn on the receiver, place the red dot on the back of
the transmitter to the red dot on the receiver. Hold the two
red dots together for a moment until the LED light on the
receiver comes on.
To turn off the receiver, repeat the same procedure
holding the two red dots together momentarily. The LED
light will turn red for a brief moment indicating that the
receiver has now shut off.
The transmitter does not have an on/off button and will
only activate when the buttons are pressed.

10
2) Front Buttons
Pager Button
The Pager button is the top button on the face of the
transmitter. Pressing the Pager button will give a vibration
for as long as the button is held down, up to 12 seconds.
Pager
Tone
1) Stimulation Level Lock Toggle Switch
When the toggle switch is in the down position, the
stimulation level will be locked and will not change even
if the Rheostat Dial moves. When the toggle switch is
in the up position, the stimulation level will be unlocked
and can be changed. Please check the stimulation level
when unlocking the toggle switch to make sure you are
correcting your dog at the right level since it may have
moved.
2. Transmitter Button Function
Unlock
Lock

11
3) Side Buttons
Nick Button
The Nick button is located on top on the left side of the
handheld transmitter. When the Nick button is pressed,
the receiver emits a single pulse of electrical stimulation.
Constant Button
The Constant button is located on the bottom of the left
side of the handheld transmitter. Pressing the Constant
button gives continuous stimulation as long as the
button is pressed, for up to 12 seconds. If the button
is not released after 12 seconds, the stimulation will
automatically turn off as a safety feature. The receiver
will be ready to be reactivated once the button has been
released.
Nick
Constant
Tone Button
The Tone button is the lower button on the face of the
transmitter. Pressing the Tone button will give an audible
tone for as long as the button is held down, up to 12
seconds.

12
3. Receiver Fitting
Proper Fit
The receiver should be fitted so that the surgical
stainless steel contact points press firmly against the
dog’s skin. You should be able to fit two fingers under
the collar strap. The best location is on either side of the
dog’s windpipe.
Improper Fit
A loose fit can allow the receiver to move around on the
dog’s neck. When this happens, the contact points may
rub against the skin and cause irritation. If the receiver
is too loose, the contact will not be consistent and cause
the corrections to be inconsistent. Dogtra uses surgical
stainless steel contact points and anti-microbial plastic
to protect the dog’s skin.
Attention!
Leaving the receiver in the same location on the
dog’s neck for an extended period of time can cause
skin irritation. If the dog is to wear the receiver for
long periods, occasionally reposition the receiver
so that the contact points are moved to a different
location on the dog’s neck. Make sure you check for
skin irritation each time you use the unit.

13
The 200NCPT has a Rheostat Dial on the front of the
transmitter (0 is the lowest and 100 is the highest).
Remember that you will need to adjust the setting (upward
or downward) depending on your dog’s temperament and
threshold for stimulation. Always start at the lowest level
and work your way up. The appropriate level can be found
when the dog responds to the stimulation with a mild
reaction. Also, as the dog’s attitude changes, especially
during times of increased excitement or distraction, you
may need to adjust the intensity level.
NOTE: The stimulation intensity can be adjusted even
while the stimulation is in use.
4. Finding the Right Stimulation

14
Typical range
Maximum range Minimum range
5. Maximizing the Distance
The 200NCPT has a 1/2-mile range. Depending on the way
you use your transmitter, the range may vary.
To get the greatest range, hold the transmitter away from
your body and avoid touching the antenna. Keep your unit
properly charged for maximum signal strength.

15
6. LED Indicator
The LED indicator flashes every 4 seconds when the
receiver is on and ready for use. The LED indicator will
blink on both the transmitter and the receiver when the
transmitter buttons are pressed.
The LED indicator color indicates the battery life level.
Green = Full charge
Amber = Medium charge
Red = Needs charge
If the unit is used while the LED indicator is red, it may
shut down automatically.
Receiver Indicator Light
When the Constant button on the transmitter is pressed,
the receiver indicator light will glow steadily (either green,
amber, or red based on the remaining battery life), as
long as you hold the button down, for up to 12 seconds.
When the Nick button is pressed, the light comes on for a
fraction of a second.

16
7. Charging the Battery
The 200NCPT uses lithium polymer batteries. Recharge
the unit if the indicator light is red, the system does not
turn on, or the system will not stay on when any button is
pressed.
NOTE 1: Only use Dogtra-approved batteries, chargers,
and accessories for your Dogtra e-collars. This will prevent
any damage that can be incurred from attempting to use
a different charger.
NOTE 2: The unit has a partial charge when it leaves the
Dogtra facility. Upon receipt of the e-collar be sure to give
it a full 2-hour initial charge before the first use.
NOTE 3: When a charger is not in use, disconnect it from
the power source. Fully charge the batteries if the unit is
to be stored without use for a period of 3 months or more.

17
Follow the steps below to charge your system:
1. Open the rubber plugs on the battery charging
receptacles and plug in the charging cable.
2. Plug the charger into a 120-volt wall outlet or, if using
the auto charger, plug into a cigarette lighter only for
lithium polymer batteries (use a 220 volt European
charger for Europe). All indicator lights should glow red
when properly plugged in and the unit will automatically
shut off during the charging process. You will need to
turn the unit on again before use once the unit is fully
charged and unplugged from the battery cable.
3. The lithium polymer battery is fully charged within
2 hours. The lights will stay red during the charging
process and turn green once the unit is fully charged.
4. After charging, cover the battery charging receptacles
with the rubber plugs.

18
Your dog must know some basic obedience commands
before beginning training with the 200NCPT. A dog
learns by first being shown a command, followed by
lots of repetition over an extended period. As the dog
becomes proficient at obeying these commands, the
trainer can introduce distractions and different locations
to strengthen them.
Obedience Training on the Leash
Your dog must fully understand the obedience commands
(sit, stay, here, heel, and kennel) before using the e-collar
for reinforcement of these commands. A leash attached
to a standard collar is used to "teach" the dog the basic
obedience commands (here, heel, sit, and stay). A tug
on the leash/collar is used to reinforce the command.
When the dog complies with the command, use positive
reinforcement/praise. Once the dog understands these
commands, the e-collar can be used to reinforce them.
Beginning E-Collar Training
When you feel your dog understands the obedience
commands on the leash we can now start with the e-collar
training. With the dog on the leash and wearing the
e-collar, continue with your obedience drills. Apply light
stimulation when a command is given; the stimulation can
be removed as the dog complies. Through repetition, the
dog learns to perform the command.
The final step is the avoidance phase in which the dog
learns that he can avoid the stimulation altogether
by performing your commands. When these training
procedures are complete, the e-collar is used as a
GENERAL TRAINING TIPS

19
reminder when the dog does not comply with your
commands at home or in the field. Keep your initial
training sessions short and positive as dogs have a short
attention span.
How Much Stimulation to Use
Always start with low levels of stimulation and work
your way up depending on the disposition of your dog
and the given situation. By using the correct amount of
stimulation to get your point across, you will have a more
controllable environment and a dog that is under less
stress. Animals (and humans) perform better in a less
stressful environment.
For more training information, please visit our website at
www.dogtra.com.

20
MAINTENANCE
Basic maintenance
Be sure the rubber-charging cap is securely in place
when the e-collar is in use. After each training session,
carefully inspect the unit for any missing parts or damage
to the casing. Damaged or broken casing may affect the
waterproof guarantee on the unit. After confirming that
there is no damage to the casing, rinse the receiver and
clean out any dirt or debris.
Storage maintenance
The 200NCPT should be fully charged before storing for
extended periods. While in storage, the unit should be
given a full charge once a month and before the first use.
Store the units in room temperature. Do not keep the units
exposed to extreme climates.
Troubleshooting
If the unit is malfunctioning, please refer to the
“Troubleshooting Guide” before sending it to Dogtra for
service. If you have any questions or concerns, you may
email them to [e-mail], or call customer service
at [phone].