Dover Dow-Key Microwave 3205 User manual

Model 3205
Solid State Matrix System
Operation Manual
Document No. 49101-130 Rev. 1

Copyright Dow-Key Microwave Corporation 2004, All rights reserved.
Information in this publication supercedes that in all previously published material.
Specifications and price change privileges reserved.
Printed in the U.S.A.
Dow-Key is a registered trademark of Dow-Key Microwave Corp.

ii
WARRANTY
Dow-Key Microwave Corporation warrants this product to be free from defects in
material and workmanship for a period of 1 year from date of shipment. This warranty
does not apply to defects resulting from product tampering or modification without Dow-
Key’s express written consent. This warranty also does not apply to software, non-
rechargeable batteries, power supplies, or problems arising from normal wear or failure
to follow instructions.
To exercise this warranty, contact Dow-Key Microwave headquarters in Ventura,
California. You will be given prompt assistance and return instructions. Send the
product, transportation prepaid, to the Dow-Key headquarters. Repairs will be made
and the product returned within the quoted period of time, transportation prepaid.
Repaired or replaced products are warranted for the balance of the original warranty
period, or at least 90 days.
NEITHER DOW-KEY MICROWAVE CORPORATION NOR ANY OF ITS EMPLOYEES
SHALL BE LIABLE FOR ANY DIRECT, INDIRECT, SPECIAL, INCIEDENTAL OR
CONSEQUENTIAL DAMAGES ARISISNG OUT OF THE USE OF ITS INSTRUMENTS
AND SOFTWARE EVEN IF DOW-KEY MICROWAVE CORPORATION HAS BEEN
ADVISED IN ADVANCE OF THE POSSIBILITY OF SUCH DAMAGES. SUCH
EXCLUDED DAMAGES SHALL INCLUDE, BUT ARE NOT LIMITED TO: COSTS OF
REMOVAL AND INSTALLATION, LOSSES SUSTAINED AS THE RESULT OF INJURY
TO ANY PERSON, OR DAMAGE TO PROPERTY.

iii
Manual Revision History
The revision history shown below lists of all revisions and addendums created for this
manual. The revision level increases numerically as the manual undergoes subsequent
updates. Addendums are released between revisions and contain important change
information that the user should incorporate immediately into the manual. When a new
revision is created, all addendum associated with the previous revision of the manual
are incorporated into the new revision of the manual. Each new revision includes a
revised copy of this history page.
Revision 1 (Document Number 49101-130) …………………………. December 2007

iv
Table of Contents
1 General Information
1.1 Introduction………………………………………………………………………… 1
1.2 Specifications ……………………………………………………………………. 1
1.3 Safety Precautions ……………………………………………………………….. 2
1.4 Inspection …………………………………………………………………………. 2
1.5 Maintenance ……………………………………………………………………. 3
1.6 Repacking for Shipment………………………………………………………….. 3
2 System Layout
2.1 Front Panel Layout …………………………………………………………….…. 4
2.2 Rear Panel Layout ……………………………………………………………….. 5
2.3 Schematic Layout ……………………………………………………………..… 6
3 Connections
3.1 Power Connections …………………………………………………….………….. 7
3.1.1 Line Voltage…………..………………………………………………………………7
3.1.2 Line Power Connection ………………………………………………………….….7
3.1.3 Line Fuse Replacement ……..………………………………….………..…………7
3.2 Ground Connection …………….………………………………………………..….8
4 Configuring the Matrix
4.1 Configuring the Matrix …………………………………………………………….9
4.2 MAC Address …………………………………………………………………….. 9
4.3 Ethernet Connections …………………………………………………………….9
4.4 Turning on the Unit …………………………………………………………………10
4.5 Calibrating the Touch Screen ………………………………………………….. 10
4.6 Testing the Ethernet Connections ……………….……………………………..10
4.7 Communication Problems ………………………….…………………………….11
4.8 Power Failure ………………………………………………………………………11
5 Manual (Local) Operation
5.1 Front Panel Controls …………………………………………………………… 12
5.2 Manual Operation using the Touch Screen …………………………………… 13
5.3 Setting Multiple Outputs to a Single Input …………………………………… 14
5.4 Disconnecting a Path …………………….………………………………………15
5.5 Clear All …………………………………..……………………………………… 15
5.6 Setup ………………………………………………………………………………. 16
5.6.1 Setup - Color …………………….………………………………………………..17
5.6.2 Setup – Output ……………………….……………………………………………..18
5.6.3 Setup – Input Names ……………………………………………...……………..19
5.6.4 Setup – Network Name …………...………………………………………………..20
Port Number