DREAMS CAMBRIDGE BED User manual

2. If you follow the instructions carefully the end result shoud be worth
the effort.
Before you
Start, here
is some
helpful advice
5. To ensure an easier assembly, we strongly advise that all fittings are
only finger tightened during initial assembly.
In the unlikely event that this product has missing or damaged parts,
please call 0844 292 0000 to obtain spares
7. Keep glue and fittings out of chidren's reach.
6. We recommend a periodic check on all fixing points to make sure they
remain fully tightened.
4. Assemble this product on a carpet.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
1. We suggest you spend a short time reading through this leaflet and
then follow the simple step by step instructions.
Assembly Instructions
CAMBRIDGE BED
Minimum No.of people
recommended to assemble
this product :
Approx assembly time :
2
3/4
hour

Component parts and fittings contained in the box
PARTS
1 ( 1piece )
2
( 1piece )
4 ( 1piece )
3 ( 1piece )
FITTINGS
x 08pcs
D
F
G
H
C
x 02pcs
x 04pcs
Note : The following fittings will be found in the box which contains the
Slat Frame, NOT with the rest of Assembly Kit
Lx 08pcs
x 01pc
E
x 04pcs
x 04pcs
(M6x45)
(M6x20)
Mx 01pc
Kx 02pcs
Ix 06pcs
(4x35)
Jx 06pcs

Step 2
Connect Side Rails 2
and 4 to Footboard
3 with
using Allen key E.
Note
:Do not fully
tighten at this point
Step 1
ASSEMBLY
2
Repeat the process
outlined in step 1 with
the Headboard 1.
Once the side Rails 2
and 4 have been
connected to both the
Headboard 1 and
footboard 3, fully
tighten all screws,
using Allen Key E as
shown
Screws F by
3
4
E
F
E
F
3
2
4
1

Identify the slat system you have purchased...
Standard wooden slat system
Sprung slat system
Tu r n to steps ,4,53
Turn to step 6
x2
Kx1 M

Sprung Slat System Assembly
Adjust leg height to suit bed frame
x8
LD
K
M
K
L
Step 3
Step 4

ASSEMBLY
D
G
C
H
Position the Slat Frame
so that the holes in the
Frame align with those
in the Side Rails 2 and
4. Secure the Frame to
the Side Rails by
threading Bolt G though
Washer C and through
the holes in the frame
and the Side Rails.
Finally, tighten by JCN
Nut H onto the Bolt G
from the underside of
the Side Rail, as shown
DREAMS SPRUNG
SLAT SYSTEM
Step 5
Step 6 DREAMS FIXED WOOD
SLAT SYSTEM
Position the Solid Wood
Slat so that the holes in
the Slats align with
those in the Side Rails 2
and 4. Secure the solid
wood slats to the Side
Rails by threading
screw J through Washer
I and through the holes
in the slats and the Side
Rails. Finally, tighten
Screw J, using a
screwdriver into the
Side Rail, as shown
I
J
FIXED WOOD SLAT ASSEMBLY