DREAMS KIMBERLEY BED User manual

1 of 5
KIMBERLEYBED
Assembly Instructions
NOTE: It will require two people to assemble this bed. Assembly should be carried out in the room that
the bed will be used in.
1. We suggest you spend a short time reading through this leaflet and then follow
the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the assembly
should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children’s reach.
In the unlikely event that this product has missing or damaged parts,
p
lease call
to obtain spares
Before you
Start, here
is some
helpful advice
Minimum No. of people
Recommended to assemble
This product.
Approx assembly time:
X

2 of 5
Component parts and fittings contained in the box
PARTS Fittings
A
B
C
D
E
F
G
H
I
4MM Allen key 1pc
M6 x 35 Bolt 6pcs
M6 x 22 Jcn Nut 6pcs
Spanner 1pc
1 piece
1piece
2 pieces
Connector 8pcs
Connecting bolt 8pcs
M8 Nut 8pcs
Ɏ8 Spring washer 8pcs
Dowel 4pcs

3 of 5
ASSEMBLY
1) Screw the connecting bolt (B) into the
headboard (1) and footboard (2).
1) Knock the dowels (E) into the holes
indicated on the side rail (3).
2) Carefully fit the side Frames to the
headboard and footboard.
Use connectors (A), Spring Washer (D)
and Nuts (C) to fix the unit. (See inset).
STEP 1
STEP 2

4 of 5
ASSEMBLY
NOTE: Slats not supplied shown
for reference only.
Both slats on “step 3---step 6”
can be assembled to the
bedstead. you can to make a
choice between the two slats.
1) Adjust the support leg height have the
four mode, you can according to the
bed height, choice the right mode to fix
in the “STEP 3”.
2) If need, you can adjust by screwing in
or out the lower part in the bottom of
the leg .
1) Use the bolt to fix the leg onto the slats
frame.
STEP 3
STEP 4
Ⴜ
1 Ⴜ
2 Ⴜ
3
*8
Ⴜ
4
Choice this mode

5 of 5
ASSEMBLY
1) Carefully locate the slats frame onto the
bed.
2) Use bolt (F) and JCN Nut (G) to fix the
slats frame onto the bed.
1) Carefully locate the slats frame onto
the bed.
2) Use bolt (F) and JCN Nut (G) to fix the
slats frame onto the bed.
STEP 5
STEP 6