DREAMS Deacon bed User manual

Deacon bed
Assembly Instructions
1. We suggest you spend a short time reading through this leaflet and then follow
the simple step by step instructions.
2. If you follow the instructions carefully the end result should be worth the effort.
3. Do not discard any of the packaging until you have checked that you
have all the parts and the pack of fittings.
4. Assemble this product on a carpet.
5. To ensure an easier assembly, we strongly advise that all fittings are only
finger tightened during initial assembly. Only upon completion of the.
Assembly should all fixing points be fully tightened.
6. We recommend a periodic check on all fixing points to make sure they remain
fully tightened.
7. Keep glue and fittings out of children s reach.
In the unlikely event that this product has missing or damaged parts, please call
03442 920000 to obtain spares
Before you
Start, here
are some
helpful
advices.
Revision number 1/1
BEFORE STARTING ASSEMBLY PLEASE REFER TO THE OWNERS MANUAL
SUPPLIED WITH YOUR SLEEPMOTION 200i BED BASE AND FOLLOW THE
INSTRUCTIONS TAKING NOTE OF ANY SAFETY PRECAUTIONS OR
OPERATIONAL SAFETY REQUIREMENTS OF THE INSTALLATION. BUILD THE
BED BASE FIRST USING ONLY THE EIGHT LONGER LEGS 6”(15cm),SEE
STAGE 1.IMPORTANT: PLACE THE BASE IN FINAL POSITION IN THE ROOM
OF USE, CONNECT THE POWER AND CHECK THE OPERATION THEN STEP
BY STEP FOLLOW THE BED ASSEMBLY INSTRUCTIONS BELOW, TO BUILD
THE BED AROUND THE SLEEPMOTION 200i BED BASE
NOTE: If you choose to purchase the
sleepmotion bed, please use this AI’

M6x35mm x 8 pcs
M6 Washer x 8 pcs
M4Allen key x 1pcs
M5Allen key x 1pc
Revision number 1/1
PARTS
Fittings
QTY
1
4
2
A
B
D
1
NO. PART LIST
(1) HEADBOARD
(2) WOODEN FEET
(3) FOOTBOARD
(4) SIDE RAILS
C

ASSEMBLY
STEP 1
(1). Screw in the Legs and put
Bed Base in the Position in which
it will be used
Revision number 1/1

ASSEMBLY
STEP 2
(1). Attach the Wooden Feet to the
headboard and footboard by using
bolt (A) 、washer (B) and
Allen Key (C)
(2). Loosen the pre-assembled bolts
on the headboard and footboard
with the Allen Key(D)
Note: Leave 10 mm protruding as
in the diagram
Revision number 1/1
M4 Allen key × 1pcs
M5 Allen key × 1pcs
A
M6×35mmx8pcs
B
C
D
M6 Washer x8pcs
D

ASSEMBLY
STEP 3
(1). Assemble Head End and one
Side Rail (4)
Revision number 1/1

ASSEMBLY
STEP 4
Raise the Head and Foot Ends of
the Bed Base
Revision number 1/1

ASSEMBLY
STEP 5
Position Foot End and connect
Side Rail brackets.
Revision number 1/1

ASSEMBLY
STEP 6
Make sure everything is working
properly then fit second side rail (4)
Revision number 1/1

ASSEMBLY
STEP 7
MAKE CERTAIN THE BED IS
SQUARED UP .AS SHOWN ON
THE RIGHT.
Square up the Bed then tighten Bolts
Revision number 1/1
C
D
M4 Allen key × 1pcs
M5 Allen key × 1pcs
D

ASSEMBLY
STEP 8
Make Certain Gaps around the
Bed Base are correct
Revision number 1/1