DSC powerseries 9047 User manual

The following 9 steps are intended to simplify the installation
process and help you move quicker to your next install
PANELS, KEYPADS & MODULES
Quick-Start
Installation Guide
PowerSeries™9047
Contact your DSC distributor
www.dsc.com
1-888-888-7838
PowerSeries 9047
1. Remove Front Plate
To remove the front plate, place a small screwdriver in the bottom left and right-hand corner slots
of the system.
2. Route Telephone Wiring
Begin by routing telephone line wiring, AC and any inputs/outputs that may be required, through the
back plate and wire them to the terminal block.
3. Mount the Back Plate
Determine placement location and mount the back plate to the wall using drywall plugs (4) and
screws (4).
WWW.DIYALARMFORUM.COM

PANELS, KEYPADS & MODULES
Quick-Start
Installation Guide
PowerSeries™9047
Contact your DSC distributor
www.dsc.com
1-888-888-7838
P/N 29007479 R001 Printed in Canada
5. Attach the Front Plate
Install the front plate by simply snapping it onto the back plate.
6. Power up the System
Apply power to the PowerSeries 9047 by plugging in the transformer.
7. Enroll Wireless Devices
Use the quick enroll feature found in section [898] to enroll wireless devices.
8. Programming the PowerSeries 9047
Quickly program (4-digit code) the functions required for basic operation through template
programming, found in section [899]. Code prompts exist for pre-defined zone definitions, reporting
code formats, communication call directions, and DLS setup. Once all codes have been programmed,
you will be prompted to enter the monitoring station telephone number and account code, DLS access
code, entry and exit delays, and installer code.
9. Placement Testing
The proposed placement of each wireless device should be tested before it is mounted by entering
section [904]. Testing the signal strength between the PowerSeries 9047 and wireless devices can be
accomplished in a group (global placement testing) or individually.
4. Connect the Battery Cable
Ensure the battery cable is properly connected.
WWW.DIYALARMFORUM.COM