Dynojet Power Commander III USB User manual

2002-2003 Yamaha YZF R1 - PCIII USB - 1i405-411
2002-2003 Yamaha YZF R1
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Parts List
1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
1 Velcro®Strip
1 Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port

1 Remove the main seat and the
passenger seat / solo cover.
2 Lift the front of the fuel tank up.
3 Locate the connectors shown in
Fig. A. These connectors are
located behind the throttle bod-
ies on the left hand side of the
bike.
4 Unplug the two connectors
shown in Fig. A.
5 Plug the fuel connectors from
the PCIII (clear connectors) in-
line of the stock wiring harness
(Fig. B).
6 Plug the TPS connectors from
the PCIII (white connectors) in-
line of the stock wiring harness
(Fig. C).
Fig. AFig. B
Fig. C
i405-411 www.powercommander.com 2002-2003 Yamaha YZF R1 - PCIII USB - 2
Unplug these connectors
PCIII connector
Stock connector
PCIII connector
Stock connector

7 Attach the ground wire from the
PCIII to the negative side of the
battery (Fig. D).
8 Install the PCIII in the rear sec-
tion of the trunk using the sup-
plied velcro (Fig. E). Make sure
to clean both surfaces first with
alcohol.
Fig. DFig. E
i405-411 www.powercommander.com 2002-2003 Yamaha YZF R1 - PCIII USB - 3
Ground wire from PCIII
PCIII wiring harness