Elite Screens EVANESCE TAB-TENSION Series Guide

Updated 2/28/2017 1 www.eliteproav.com
Circuit Board Replacement Instructions
for Saker Plus/Evanesce Plus/ Evanesce Tab-Tension/Kestrel Stage Series
For technical support or further assistance, call 877-511-1211 x604
ATTENTION: Please make sure the version number and the Voltage of the circuit board matches the
version number and the Voltage of the screen. EliteProAV™ does not recommend making unnecessary
adjustments to the screen, as improper adjustments will damage the unit and void your warranty.
1. Open the control box and remove the cover. Press in the release tabs on both sides and pull to
remove.
2. Press in the clips on the white terminals, then carefully pull out to remove the two terminals.
Release tabs.
Two white terminals.

Updated 2/28/2017 2 www.eliteproav.com
3. Remove the three screws that secure the circuit board with a Phillips head screwdriver. Set the
screws aside to later secure the new circuit board.
4. Utilize the saved screws to secure the new circuit board in same location of the previous.
5. Insert the two sets of white terminals into the new circuit board.
Finished disassembly.
Three screws.
Three screw locations.
Two white terminals.

Updated 2/28/2017 3 www.eliteproav.com
6. Replace circuit board cover. Be sure to listen for a "click" to insure the cover is secure.
For a local EliteProAV™ contact or Technical Support, please visit
www.eliteproav.com
Finished assembly.