Elo TouchSystems 0702L User manual

Revision A
P/N E915161
www.elotouch.com
Quick Installation Guide
0702L Touchmonitor
© 2019 Elo Touch Solutions, Inc. All rights reserved.
The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no
representations or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a
particular purpose. Elo reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation
of Elo to notify any person of such revisions or changes.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise without prior
written permission of Elo Touch Solutions, Inc.
Elo and the Elo logo are either trademarks or registered trademarks of Elo Touch Solutions, Inc..
North America
800-ELO-TOUCH
Tel [phone]
Fax [phone]
[email protected]
Europe
Tel [phone]
Fax [phone]
[email protected]
Asia-Pacific
Tel [phone]
Fax [phone]
[email protected]
Latin America
Tel [phone]
EloSales.LAT[email protected]
Elo Touch Solutions Technical Support
Online self-help: www.elotouch.com/support
Power Button Micro USB connection Serial Number
75mm mounting interface

Download and install the latest DisplayLink
drivers at www.elotouch.com/support.
Note: DisplayLink driver installation requires
another display to be functioning during
driver installation because the 0702L will not
function without the drivers installed.
Connect the micro USB cable. Ensure the
rubber gasket (red) is all the way inside the
cable cover area.
1
2
3Install the cable cover by installing the top
side rst and rotating it down. Secure the door
with the M3 screw included.
4
5
Monitor can be mounted to any standard
75mm x 75mm VESA mounting bracket
using four M4x8mm screws.
Connect the Data Connector of the Y-Cable to the host PC USB port.
Note: Some computers also require connecting the AUX Power
connector to the host PC.
AUX Power Connector
75mm
75mm
Data Connector
Go to www.elotouch.com/support to download user manual.
请访问www.elotouch.com.cn 获取用户手册 请保留备用