Elo TouchSystems EloPOS Z30 User manual

Revision B
P/N E232225
www.elotouch.com
Quick Installation Guide
EloPOS Z30
© 2021 Elo Touch Solutions, Inc. All rights reserved.
The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no
representations or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness for a
particular purpose. Elo reserves the right to revise this publication and to make changes from time to time in the content hereof without obligation
of Elo to notify any person of such revisions or changes.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer
language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise without prior
written permission of Elo Touch Solutions, Inc.
Elo and the Elo logo are either trademarks or registered trademarks of Elo Touch Solutions, Inc.
America
800-ELO-TOUCH
Tel [phone]
[email protected]
Europe (EMEA)
Tel [phone]
[email protected]
Asia Pacific
Tel [phone]
[email protected]
Elo Technical Support
Online self-help: www.elotouch.com/support
Contents
EloPOS Z30 (1)
150W DC Power Adapter and cables
M3x5mm I/O cover security screw (1)
Stand Mounting bracket and screw (1)
Tie-wraps (2)
USB-C (E483135 Only)
Cash Drawer
USB-A
DC Power In
Powered USB
USB-A
Ethernet
I/O Connections

Go to www.elotouch.com/support to download user manual.
Remove the cable cover door to access the I/O connections.
Route the DC power cable through the hole in the bottom of
the stand and connect it as shown. Connect other I/O cables
as needed (see back page) Make sure all cables route
through the plastic clip at the bottom.
1 3
4
5
6
2
Clip
Power
Power
Button
Mount the system to a table (optional). Skip to Step 6 if not
mounting to a table.
Secure the mounting bracket to the table using appropriate
screw type and length. Elo suggests M4 or #10 screw
diameter.
Lower the system onto the bracket and sldie it back
ensuring the bracket engages the screws on the bottom
side.
Secure the system to the bracket using the screw included
in the accessory box.
Power on the system when installation is complete.