Enabling Devices Clubhouse Fun Mickey 9411 User manual

For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST)
1-800-832-8697
[email protected]
Clubhouse Fun Mickey #9411
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. [phone] / Fax [phone]
Toll Free 800.832.8697
www.enablingdevices.com

Sing and giggle!
Activate your capability switch and Mickey will sing their favorite
song, the “Hot Dog!” song. Activate your switch a second time and
their will burst into giggles. Comes with stand for easy play. Size:
8"L x 6"W x 12"H. Requires 2 AA Batteries. Weight: 1 lb.
Operation:
1. Mickey requires 2 AA batteries (Not included) to operate. Use
alkaline batteries only (e.g. Duracell or Energizer brand). Do not
use rechargeable batteries or any other type of batteries
because they supply lower voltage and the unit will not perform
properly. Never mix old and new batteries together or different
brands or types together.
2. The battery compartment is located inside the Velcro enclosed
compartment on their back. Open the flap then, using a Phillips
head screwdriver open and remove the batter cover. Next install
2 AA batteries paying close attention to proper battery polarity.
3. Replace the battery compartment cover and secure it with the
screw. The ON/OFF has been glued in place do to switch
adaption. We have included a stand to use with Mickey so that
you can sit him up when using a switch. There is Velcro on the
back of Mickey to hold him in place on the stand. There is also
a cutout at the base of the stand to put his tail and switch cable
through.
4. Connect Mickey to any external capability switch (not included)
via the jack located at the end of his cord, Mickey is equipped
with a 1/8" jack for use with external capability switches with a
1/8" plug. Make sure to plug your switch all the way in. There
should be no gaps.
5. Actuate your external capability switch or squeeze Mickey’s
tummy and Mickey will sing his favorite song, the “Hot Dog!”
song. Activate your switch a second time and Mickey will burst
into giggles.
6. When finished using disconnect your switch to prevent false
activations and to prevent battery drain.
Troubleshooting:
Problem: Mickey does not function correctly.
Action #1: Replace the batteries paying close attention to proper
battery polarity.
Action #2: Make sure that the connection between the external
capability switch and the jack is pushed in all the way. There should
be NO gaps.
Action #3: Try your switch with another switch operated toy/device
in an effort to rule out your switch as the source of the problems.
Care of Unit:
If you will not be using Mickey for an extended amount of time, we
recommend removing the batteries.
Do not submerge the unit in water, as it will damage the electrical
components. Mickey is surface washable only.
Rev 10/10/17