Enabling Devices 889 User manual

For Technical Support:
For Technical Support:For Technical Support:
For Technical Support:
Call our Technical Service Department
Monday through Friday, 9 a.m. to 5 p.m. (EST
1-800-832-8697
[e-mail]
Puppy Dog #889
USER’S GUIDE
50 Broadway
Hawthorne, NY 10532
Tel. [phone] / Fax [phone]
Toll Free 800.832.8697
www.enablingdevices.com

See pooch walk!
See pooch walk!See pooch walk!
See pooch walk!
Puppy Dog walks, swings his head, barks and wags his tail when
switch is activated. A great cause and effect experience. Size: 5"L x
6"H. Requires Capability Switch and 2 AA Batteries. Weight: ½ lb.
Operation:
Operation:Operation:
Operation:
1. Puppy Dog requires 2 AA batteries (not included to operate.
Alkaline batteries must be used (e.g. Duracell or Energizer
Brands . Do not use rechargeable batteries because they supply
a lower voltage and the unit may not perform as well. Never mix
old and new batteries together or different brands or types
together.
2. Turn Puppy Dog upside down to reveal the battery compartment.
Install 2 AA batteries paying close attention to proper battery
polarity.
3. Replace the battery compartment cover and secure it. Connect
Puppy Dog to any external capability switch (not included via the
jack located at the end of Puppy Dog’s cord. Puppy Dog is
equipped with a 1/8” jack for use with external capability
switches with a 1/8” plug. Make sure to make a tight
connection. There should be no gaps.
4. Actuate your external capability switch and Puppy Dog will spring
to life! He will walk forward and bark.
5. Puppy Dog will remain on while the external capability switch
continues to be actuated. Once you release the external
capability switch, there will be a brief delay, and then Puppy Dog
will turn off.
Troubleshooting:
Troubleshooting:Troubleshooting:
Troubleshooting:
Problem:
Problem: Problem:
Problem: Puppy Dog does not function correctly.
Action #1:
Action #1: Action #1:
Action #1: Replace the batteries paying close attention to proper
battery polarity.
Action #2:
Action #2:Action #2:
Action #2: Make sure that the connection between the external
capability switch and the jack is TIGHT. There should be NO gaps.
Action #3:
Action #3: Action #3:
Action #3: Try your switch with another switch operated toy/device
in an effort to rule out your switch as the source of the problems.
Care of Unit:
Care of Unit:Care of Unit:
Care of Unit:
• Do not inhibit Puppy Dog’s movement, as this may cause
irreversible damage.
• Do not lift Puppy Dog up by his head, tail or legs, or drop Puppy
Dog.
• If you will not be using Puppy Dog for an extended amount of
time, we recommend removing the batteries.
Do not submerge
Do not submergeDo not submerge
Do not submerge the unit in water, as it will damage the electrical
components. Puppy Dog is surface washable only.
Rev
Rev Rev
Rev 2
22
2/15
/15/15
/15/17
/17/17
/17