Enwork Concurrence Conference Table User manual

Concurrence Conference Table Installation Instructions
Rev 0315

P a g e | 1

P a g e | 2
STEP 1
ATTACHING HORIZONTAL BEAMS
THE BEAM SITS INSIDE OF THIS TAB AND
RESTS ON THE TOP OF COLUMN. BEAM
MUST REST ON TOP OF COLUMN FOR
PROPER FIT.
USE PHILLIPS HEAD SCREWDRIVER TO
INSTALL QTY: , 1/4-“- 0X ½” SCREWS PER
COLUMN
DO NOT TIGHTEN YET

P a g e | 3
STEP 1 CONT.
ATTACHING HORIZONTAL BEAMS
REPEAT THE PREVIOUS STEPS TO
ATTACH
ALL PANEL BASES TO HORIZONTAL BEAMS
ENSURE THAT PANEL BASES ARE SQUARE
TO HORIZONTAL BEAM AND TIGHTEN
INSTALLED FASTENERS SECURELY

P a g e | 4
STEP
SECURING WORK SURFACE BRACKETS
USE
PHILLIPS HEAD SCREWDRIVER TO
INSTALL AND TIGHTEN QTY: , ¼”- 0 X 3/4”
FLAT HEAD SCREWS PER COLUMN
REPEAT FOR ALL WORK SURFACE
ATTACHMENT BRACKETS
WORK SURFACE ATTACHMENT BRACKET

P a g e | 5
STEP 3
ATTACHING THE WORK SURFACE
VIEW OF UNDERSIDE OF WORK SURFACE
INSERT BISCUTS INTO SLOT CUTS ON SEAM
& BRING BOTH SURFACES TOGETHER
INSERT CONNECTOR BUT DO NOT TIGHTEN
ALL THE WAY. ADJUST THE WORKSURFACES
SO THAT THE EDGES ARE ALIGNED.
-TIGHTEN ALL CONNECTORS

P a g e | 6
STEP 3 CONT.
ATTACHING THE WORK SURFACE
WORK SURFACE
TRANSPARENT FOR CLARITY
CENTER THE WORK SURFACE ON THE TABLE
BASE ASSEMBLY & INSTALL QTY: 4 WOOD
SCREWS PER WORK SURFACE ATTACHMENT
BRACKET
WORK SURFACE ATTACHMENT BRACKET