Enwork Landing User manual

Landing
Rev A 7/30/18
Laminate Team Table
Installation Instructions

1) Parts and Fasteners Included
INSTALLATION GUIDE
24mm Cam Dowel 8mm x 1in Dowel Pins Keel Block
Keel End Panel Top Surface

1) Parts and Fasteners Included
INSTALLATION GUIDE
5/16 Flange Nut #10 x 1 Phillips Screw
Foot Bar Weldment
Angle Bracket
Optional Foot Bar Parts

2) Tools and Supplies Required
INSTALLATION GUIDE
Phillips Drive Phillips Head Screw Driver Rubber Mallet
Cordless Drill Ratchet 5/16 Deep Socket

4) Assembly:
INSTALLATION GUIDE
Fig. 2
Fig. 3
Fig. 2 Assemble Keel Block and Keels. Keel Blocks
should be assembled with the Cam Dowel surfaces
facing each other (as shown).
Fig.3 Assemble should be placed as shown (Edge
band side up)
Keel Sub Assembly
Fig. 1
Fig. 1 Install (4) Cam Dowels Pins into the (4) 5mm pre
drilled holes on the Keel. Repeat for second Keel.