Enwork TI0023 User manual

•TI0023 Laminate/Fabric Privacy/Modesty Installation Instructions

1) Parts and Fasteners Included
INSTALLATION GUIDE
•Drill/Driver •1/8” Hex Bit
•# 10 x .875” Phillips
Wood Screw
(Screw 1)
•#2 Square Bit
•¼-20 x 3/8” Low Profile
Socket Head Screw
•EM-1332
L-Bracket •¼-20 threaded insert
w/out flange **
Parts and Fasteners Needed
•6mm Hex Bit **
[Laminate Version Only **]

This page for laminate version only.
For laminate screens, use the drill and 6mm Hex bit to install required
threaded inserts. DO NOT OVER TIGHTEN. Inserts should sit flush or just
inset of laminate surface.

1) Using the drill and 1/8” Hex bit, install ¼-20 x 3/8” Low Profile Socket Head Screws and
EM-1332 as shown below. Be sure the slot of EM-1332 is facing the top of the screen.

2) After brackets are installed, hold the screen up to the back of the work surface with the
brackets flush to the bottom of the work surface.

Option A
3) Two Installation Options:
A. Install the screen flush to the edge of the work surface.
B. Install the screen ½” offset from the edge of the work surface.
Option B

4) If ½” offset on the back of the work surface is desired, align attachment brackets to the
edge of the work surface as shown below. Slot should just disappear behind the edge.

5) With screen still held in place, attach to bottom of work surface using #10 x .875” Phillips
Wood Screws, drill, and #2 Square bit.