Enwork Concurrence VS User manual

Concurrence VS Table Installation Instructions
Rev 0315

1

2
NOTE TAB. THE BEAM SITS INSIDE THIS TAB AND
RESTS ON THE TOP OF COLUMN. BEAM MUST
REST ON TOP OF COLUMN FOR PROPER FIT.
USE PHILLIPS HEAD SCREWDRIVER TO INSTALL 2,
¼”-20 X ½” SCREWS PER COLUMN.
DO NOT TIGHTEN YET
STEP 1
ATTACHING HORIZONTAL BEAMS
TO MONITOR WALL

3
NOTE TAB. THE BEAM SITS INSIDE THIS TAB AND
RESTS ON THE TOP OF COLUMN. BEAM MUST
REST ON TOP OF COLUMN FOR PROPER FIT.
USE PHILLIPS HEAD SCREWDRIVER TO INSTALL 2,
¼”-20 X ½” SCREWS PER COLUMN.
TIGHTEN ALL SCREWS
USE PHILLIPS HEAD SCREWDRIVER TO INSTALL AND
TIGHTEN QTY: 2, ¼”-20 X ¾” FLAT HEAD SCREWS
2 PLACES
STEP 2
ATTACHING HORIZONTAL BEAMS
TO PANEL BASE

4
REPEAT PREVIOUS STEPS SO THAT BOTH BEAMS
ARE INSTALLED AND TIGHTENED SECURELY.
NOTE THAT WORK SURFACE NOTCH SLIDES
INSIDE WALL EDGES
STEP 3
INSTALLING WORKSURFACE

5
HOLD WORK SURFACE SECURELY IN THE
DIRECTION OF THE ARROW.
WHILE HOLDING PRESSURE IN THE DIRECTION OF BOTH
ARROWS, INSTALL QTY: 4, PROVIDED WOOD SCREWS
TO ATTACH “L” BRACKET TO WORK SURFACE.
NOTE THAT HOLES ARE PRE DRILLED IN WORK SURFACE
NOTE THAT THE BACK OF
THE “L” BRACKET IS TO BE
TIGHT TO THE BACK OF
THE WORK SURFACE
STEP 4
SECURING WORK SURFACE

6
ATTACH “90 DEGREE NW” BRACE TO WORK
SURFACE WITH PROVIDED WOOD SCREWS
-6 SCREWS PER BRACE
90 DEGREE NW BRACE
INSTALL QTY: 4 WOOD
SCREWS (PROVIDED) PER
LZYPLATE
LZYPLATE
STEP 4
CONT.
SECURING WORK SURFACE

7
ROUTE MONITOR WIRING BEFORE
INSTALLING MONITORS.
-SEE INCLUDED
MANUFACTURES MONITOR
MOUNTING BRACKET
ASSEMBLY INSTRUCTION
STEP 5
ROUTING MONITOR WIRING

8
POWER STRIP CORD (YELLOW)
TV VIDEO CORD (GREEN)
TV POWER CORD (RED)
EXTRON POWER CORD (ORANGE)
POWER & DATA POWER CORD (PURPLE)
ATTACH PROVIDED POWER
STRIP TO BOTTOM OFWORK
SURFACE WITH DOUBLE
SIDED TAPE
INSTALL PROVIDED CABLE
GRIPPERS TO BOTTOM OF
WORK SURFACE WITH
PROVIDED WOOD SCREWS
SAMPLE WIRING DIAGRAM
ACTUAL COMPONENT PLACEMENT VARIES
DEPENDING ON TABLE SIZE AND LOCATION OF
POWER SOURCE
PROVIDED POWER & DATA UNIT
-UNIT WILL VARY
DEPENDING ON ACTUAL
ORDER
EXTRON AV UNIT
PLEASE SEE AV EQUIPMENT
MANUFACTURES INSTRUCTION (INCLUDED)
FOR DETAILED INSTALLATION STEPS
STEP 6
AV INSTALLATION

9
NOTE THAT POWER CORD DROPS
BETWEEN WALL AND RUNS THRU
BOTTOM COMPONENTS.
-POWER CAN BE RUN THRU
PANEL BASE AS WELL
ROUTE TV POWER & VIDEO
CORDS THRU THE ROUND
CUTOUTS IN WALL BACK PANEL
STEP 6
CONT.
AV INSTALLATION