Enwork LANDING XNEL363672-002 User manual

LANDING XNEL363672-
002
FOOTER BAR ASSEMBLY FOR CASTERS
Installation Guide
10/3/18 –REV A

INSTALLATION GUIDE
1) Parts and Fasteners Included
Landing End Panel
Foot Bar
Weldment Bracket
Screw 1 5/16-18 Serrated Flanged Nut .25 x 2” Hex Head Lag
Caster

INSTALLATION GUIDE
2) Tools and Supplies Required
Drill
#2 Phillips Bit
Adjustable Wrench
Ratchet Socket Socket Extension

INSTALLATION GUIDE
3) Assembly Overview
1. Lay the end panel of the table
down to gain access to the pockets
at the bottom of the panel. (Figure
1)
2. Nest bracket in the pocket on the
bottom of end panel. (Figure 2)
3. Install 2 (.25 x 2” Hex Head lag)
through the two holes of bracket into the pre-dilled holes of the
end panel. Next to the weld nut.
(Figure 3 Circled)
4. Install 4 (screw 1) into the side of
the end panel through the four
holes of the bracket. (Figure 3 See
arrow)
5. Install caster into nut on bracket
and tighten with wrench. (Not
Shown)
Note:
1. Steps 2 & 3 are repeated for
second bracket. Two brackets and
four lags are used in the assembly
2. Repeat this assembly for each end Figure 3 panel.
Figure 1
Figure 2

INSTALLATION GUIDE
3) Assembly Overview
Once both end panels have two
brackets lagged and screwed in and
caster attached. Assembly table as
standard landing. (Figure 4) Casters
not shown.
Note: “L” brackets are added for
strength. There are pre-drilled hole to
locate brackets
6. Slide footer bar between end
panels down over the brackets.
(Figure 5).
7. Install 5/16-18 serrated flanged
nut on the underside of the bracket. 2
for each end of footer bar. (Figure 6
Circled)
8. Repeat steps 6 & 7 for the other
side of the table.
Figure
6
Figure 4
Figure 5

12900 Christopher Drive Lowell, MI 49331
800.815.7251 www.enwork.com
Specifications subject to change without notice.