Enwork Stealth User manual

Stealth Conference Table Assembly 3+ Base Configurations
Rev 0915

1
FIGURE #1
FULL BASE ASSEMBLY
TOOLS REQUIRED: FASTENERS INCLUDED IN HARDWARE PACK:
#2 PHILLIPS SCREWDRIVER, OR DRIVER BIT WITH POWER TOOL 5/16-18 FLANGE NUTS ATTACHED TO 90° CORNER BRACKET
½” COMBINATION WRENCH #1 SCREW

2
FIGURE #2 - EXTRUSION BEAM
DEPENDING UPON BEAM LENGTH THE NUMBER OF TOP SUPPORT EXTRUSIONS WILL VARY. THEY SHOULD BE EVENLY SPACED BETWEEN
EXTRUSIONS AND ½ THE DISTANCE FROM THE EXTRUSION TO THE BASE ASSEMBLY
TOP SUPPORT EXTRUSION

3
FIGURE #3 - BASE ASSEMBLY AS SHIPPED
90° BRACKETS (LEFTHAND & RIGHTHAND )
FIELD INSTALLED WITH TOP OF BRACKET
FLUCS WITH TOP OF ALUMINUM EXTRUSION
TOP MOUNTING PLATE (2) PER BASE ASSEMBLY

4
FIGURE #5
NOTE PANEL RETAINER PLATE, SCREWS AND LEVELERS ARE INSTALLED AT THE FACTORY. LEVELERS SHOULD BE ADJUSTED AS NEED TO LEVEL
TABLE BASE ASSEMBLY PRIOR TO INSTALLING TABLE TOP
PANEL RETAINER
PLATE & SCREW
LEVELER

5
FIGURE #6
INSERT EXTRUSION ON TO BOLT PLATE, BOLT PLATE SHOULD SLIDE INTO CHANNEL IN EXTRUSION (SEE FIGURE #7)
EXTRUSION CHANNEL FOR BOLT PLATE

6
FIGURE #7
REPEAT PROCESS FOR OPPOSITE EXTRUSION, CONTINUE WITH THE OPPOSTE BASE. ONCE THE EXTRUSIONS ARE ATTACHED TO THE TWO BASES
MAKE SURE THAT THE TOP SUPPORT EXTRUSIONS (SEE FIGURE #2) ARE LEVEL WITH THE MOUNTING PLATE (SEE FIGURE #3). TIGHTEN
ALLFLANGE NUTS SECURELY USING A ½” WRENCH
PLACE TOP ON BASE ASSEMBLY AND CENTER SIDE TO SIDE AND FRONT TO BACK, OVERHANG ON THE ENDS VARIES DEPENDING UPON SIZE OF
TOP.

7
CENTER PANEL BASE OUTSIDE VIEW
NOTE: SEAM BETWEEN CROSS BEAMS SHOULD MEET IN CENTER OF PANEL BASE
RIGHT ANGLE BRACKETS LOCATED AS SHOWN BELOW

8
NOTE HOW RIGHT ANGLE BRACKETS SPLIT CONNECTION AS SHOWN

9
EXTRUSIONS ARE SHOWN IN TRANSPARENT MODE TO SEE RIGHT ANGLE CONNECTOR IN POSITION.
PLACE THIS INTO FRONT SLOT BOTH SIDES PRIOR TO CONNECTING CENTER PANEL BASE.
RIGHT ANGLE CONNECTOR

10
INSIDE VIEW SHOWING MOUNTING PLATES POSITIONED IN EXTRUSION CHANNELS
MOUNTING PLATES

11
POSITION CONNECTOR TOP PLATE OVER MOUNTING PLATE BOLTS AS SHOWN SECURE WITH (2) 5/16-18
SARRATED HEAD HEX NUTS

12
INSTALL CENTER PANEL “T” CONNECTOR SECURE WITH (4) 5/16-18 SARRATED HEAD HEX NUTS
REPEAT PROCESS FOR OPPOSITE CROSS MEMBERS.