Epilog Laser Fusion Pro 32 User manual

www.epiloglaser.com
[e-mail]
303-215-9171
Squaring the Y-Axis Actuators
Fusion Pro 32 & 48
Parts Required Tools/Materials Required
• n/a • 5/32”, 7/64” Allen Wrench
07/2023

16000 - Squaring the Y-Actuators
2
Squaring the Y-Axis
Actuators
1. Turn o the engraver.
2. Disconnect engraver from power
source.
3. Remove the le panel of the engraver:
4. Remove the exhaust plenum at the
rear of the engraver:
5. Loosen, but do not remove the three
(3) 7/64” Allen screws that secure the
le y-axis actuator to the front of the
machine chassis:
6. Loosen, but do not remove the four
(4) 7/64” Allen screws that secure the
le y-axis actuator to the rear of the
engraver chassis:

16000 - Squaring the Y-Actuators
3
7. Manually move the x-axis assembly to
the front of the engraver, ensuring that
it is square to the rear of the machine:
8. Tighten the three (3) 7/64” screws
that secure the y-axis actuator to
the chassis to the front le of the
engraver:
9. Manually move the x-axis assembly to
the rear of the engraver, ensuring that
it is square to the rear of the machine:
10. Tighten the three (3) 7/64” screws that
secure the y-axis actuator to the
chassis to the rear le of the engraver:
If further assistance is required, contact
Epilog Laser Technical Support by phone
at 303-215-9171, or by email at
[e-mail].