Evelo Galaxy SL User manual

EVELO Galaxy SL Assembly
Our Team is here to help 7 days a week
[e-mail] |877-991-7272
Feel free to reach out!
The focus of this document is to assist with the assembly of your new EVELO
Galaxy SL. The scope is intentionally narrow – The “User Guide” that was
included with your bike covers a much broader spectrum of topics: fit
adjustments, battery care, controls etc.
Watch the Assembly
Instructions Video

2ASSEMBLY OF EVELO GALAXY SL
1Begin unboxing the bike by cutting the banding then
opening the box. Use caution regarding the staples as
they can be very sharp. Remove the small boxes.
Laying the box on its side and
sliding the bicycle out of the
box is a great technique if you
are unable to li the bike.
3Carefully remove all packing material from
bike, avoid using sharp objects as to protect
the paint.
4Tools and User Guides will be in the small
black Evelo box. The pedals will be in a
small cardboard box.
2
Unboxing Your EVELO

3ASSEMBLY OF EVELO GALAXY SL
1
Connect headlight to the bike’s wiring harness. Line up the arrows on each half of the connector and press
them together. When connected, the red will be completely covered.
Attach headlight and fender assembly to fork. Position the fender as high up as possible and tighten the
bolt and nut.
2
3
Install Fender and Headlight
Remove bolt from front fork assembly.

4ASSEMBLY OF EVELO GALAXY SL
Remove the nut from the quick release skewer and slight the skewer through the hub.
1
Install Front Wheel and Fender
Install the skewer nut, at this point you only
need to just get it started.
2
Slide the wheel into the fork.
4
Remove pad spacer from the brake if installed.
It may be red, yellow, orange, or black.
3
Lower the kickstand so the bike will hold itself
upright.
5

5ASSEMBLY OF EVELO GALAXY SL
Tighten the skewer nut and close the skewer. When properly tight, it will feel firm and should leave a visible
mark on your palm aer closing the skewer.
6
Install Front Wheel and Fender
Remove the fender mounting bolt/washer
from the right side of the fork.
7
Repeat on the le side of the bike.
9
Mount fender strut to right side of the fork with
the bolt and washer as shown.
8

6ASSEMBLY OF EVELO GALAXY SL
Install Handlebars
Remove the 4 screws on top of the stem faceplate.
1
Place handlebars in stem cradle.
2Replace faceplate and the 4 screws on top
of handlebars and tighten bolts loosely.
3
Center the handlebar logo with the stem and
set grips roughly level.
4Tighten all four screws to clamp handlebar in
place.
5

7ASSEMBLY OF EVELO GALAXY SL
Install Handlebars
7
Loosen both stem clamping bolts.
6
Rotate the display forward to access the headset preload bolt, and loosen the bolt.
8Align handlebars to front wheel then snug up the headset preload bolt, so that the spacers below the stem
do not rotate easily.

8ASSEMBLY OF EVELO GALAXY SL
Install Handlebars and Adjust Saddle
10
Tighten both stem clamping bolts then rotate the display back down.
9
Open the seapost quick release.
11 Set the saddle height where it is comfortable, then close the quick release.

9ASSEMBLY OF EVELO GALAXY SL
Install Pedals
Screw pedals into crank arms securely. Installation of the pedals requires a 15 mm wrench.
There is an L and an R stamped into the end of each pedal for reference.
1
It is important to note that the pedals are threaded differently. The right pedal will be on the same side as
the chain and screws in clockwise. The le pedal goes on the side without the chain and screws in counter-
clockwise.
2

10ASSEMBLY OF EVELO GALAXY SL
Use of Battery
Two copies of the key come attached to
the handlebars.
1
The battery is heavy, please be careful. When reinstalling, push the battery into
place firmly.
3
Power up the bike and you’re ready to ride!
4
Turn the key clockwise to lock the battery in
place and counter-clockwise to unlock it.
2

11ASSEMBLY OF EVELO GALAXY SL
Serial Number Location
To register your bike on our website, you will
need to record the serial number. It is located
on the headtube of your bike, just above the
front fork.

There is considerable additional information in your “User Guide”.
Of course, if you ever have questions, our team is ready to help!
Our Team is here to help 7 days a week!
[e-mail] | 877-991-7272
Feel free to reach out!