Event Lighting DELUGE27X15 User manual

DELUGE27X15
Outdoor RGBW Wash
USER MANUAL
For safety, please read this user manual carefully before initial use.
Event Lighting reserves the right to revise the manual at any time. Information and specifications
within this manual are subject to change without notice. Event Lighting assumes no liability or
responsibility for any errors or omissions. Please consult Event Lighting for any clarification or
information regarding this item.
Version: 1 (1 September 2022)

2
www.event-lighting.com.au
Safety Instructions
Warning
• Do not open this device, there is no user-serviceable parts inside. Risk of electric shock.
• Do not look at the light source when the device is on.
Caution: This unit's housing may be hot during and after operation.
• Install this device in a location with adequate ventilation, at least 50 cm from adjacent
surfaces.
• Do not leave any flammable material within 50 cm of this unit while operating or connected to
power.
• Use a safety chain when mounting this device overhead.
• This product is rated IP65, meaning it is protected against dust and water jets from all
directions. Do not operate this device in any location where excessive heat or water beyond
the IP65 specification may affect it.
• Do not operate this device if the housing, lenses, or cables appear damaged.
• Do not connect this device to a dimmer or rheostat.
• ONLY connect this device to a grounded and protected circuit.
• ONLY use the hanging bracket to carry this device.
• In case of a serious operating problem, stop using immediately.
• The maximum ambient temperature is 40° C. Do not operate this device at higher
temperatures.
Power Input and Power Linking
This device has an auto-switching power supply that works with input voltage range of 100~240 VAC,
50/60 Hz.
Link up to a maximum of 8A. Do NOT exceed this.
Product Installation
• This fixture can be mounted in many orientations
provided each individual fixture is secured by the
use of correct mounting bracket.
• Use a safety chain when mounting this device
overhead.

3
www.event-lighting.com.au
Dimensions
Lux Chart

4
www.event-lighting.com.au
Menu Operation
Menu – Move up a level.
Up – Move selection up one item.
Down – Move selection down one item.
Enter – Select / Move down a level.
Menu
Level 1
Level 2
Description
DMX Address
001-512
Set DMX address
DMX Channel
Mode
4 Channel Mode
4 channel DMX mode
7 Channel Mode
7 channels DMX mode
8 Channel Mode
8 channels DMX mode
Dimmer Mode
Dimmer Mode 1
Dimmer Mode 2
Dimmer Mode 3
Dimmer Curve
Dimmer Curve 1
Dimmer Curve 2
Dimmer Curve 3
Dimmer Curve 4
LED Frequency
600 Hz
1200 Hz
2000 Hz
4000 Hz
6000 Hz
25 kHz
Manual Colour
Red
000-255

5
www.event-lighting.com.au
Green
000-255
Blue
000-255
White
000-255
Auto Program
Auto Color
Auto Fade
Language
English
Chinese
Display
Normal
Reverse
Flip 180°
Backlight
On
Always on
30s
Off after 30 seconds of inactivity
Fixture test
Red
Green
Blue
White
Factory Settings
No
Yes
Reset to factory settings
System Info
RDM UID
Version
Software Version
DMX Channel
Current DMX channel mode
Run time
Total usage time
User time
Time since power on
Temperature
Current temperature

6
www.event-lighting.com.au
DMX Chart
This fixture is controlled by the universal DMX 512 protocol. The DMX address is the first channel
used to receive instructions from the external controller. For independent control, each fixture must
be assigned a unique address for each of its control channels. For example, this device has three
channel modes: 4/7/8, if it’s set to 7 channel mode, and there are several fixtures need to be
independently controlled, we just simply address first fixture at 1, and second fixture at 8, third one
at 15, etc. !
• If multiple fixtures have the same DMX address, they will behave synchronically. !
• Display will flash when no DMX signal is received. !
Mode/Channel
Min
DMX
Max
DMX
4
Ch
7
Ch
8
Ch
Function
Description
1
1
Dimmer
0
255
Dimmer, 0-100%
2
2
Strobe
0
255
Strobe, slow to
fast
1
3
3
Red
0
255
Red, 0-100%
2
4
4
Green
0
255
Green, 0-100%
3
5
5
Blue
0
255
Blue, 0-100%
4
6
6
White
0
255
White, 0-100%
7
7
Colour
Temperature
0
255
Colour
temperature
8
Colour Macro
0
255
Colour macros
!

7
www.event-lighting.com.au
Technical Specifications
Photometrics
• Light Source: 27x 15W RGBW LEDs
• CRI: ≥90
• Beam Angle: 25°
• Optional Lenses: 8°/15°/45°
• Output: 2,916 lux @ 5m @ 25°
• LED Lifespan: 50,000 hours
Effects
• Dimming: 0~100%
• Strobe: 0.3-20 Hz
Movement
• Tilt: 130°, manual
Power
• Input Voltage: 100~240V AC, 50/60 Hz
• Power Consumption: 350 W
• Connection: True1 in/out
Control
• Protocol: DMX512
• Operation Modes: DMX, auto, manual, sound active, master/slave
• DMX Channels: 7/14/42
• Interface: 3-pin XLR in & out
• Display: 4-button 2.4-inch LCD control panel
• Cooling: Fanless
Housing
• Materials: Aluminium
• Finishing: Matte black
• IP rating: IP65
• Dimensions: 465*81*240 mm
• Net Weight: 6.6 kg
Warranty
Please refer to your local dealer or please contact Event Lighting Pty Ltd.