Fisher-Price G5912 User manual

w
w
w.
fi
s
he
r
-p
r
i
c
e
.
c
o
m
Please read these instructions before assembly and use of this product.
Adult assembly is required.
Tool needed for battery installation: Phillips Screwdriver (not included).
Requires four LR14 alkaline batteries for operation (not included).
Weight Limit: 9 kg (20 lbs).
Product features and decorations may vary from picture above.
G5912
IMPORTANT! KEEP INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING

2
To prevent serious injury or death
from falls and being strangled in
the restraint system:
- Always use the restraint system.
- Not recommended for children
who can sit up by themselves
(6 months approximately, until
9 kg, 20 lbs).
• Never leave child unattended.
• It is dangerous to use this product
on an elevated surface.
WARNING
Warning and Caution
This package contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
Consumer Information
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,
Victoria 3121 Australia. Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
ASIA
Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre,
Harbour City, Tsimshatsui, HK, China.
Mattel UK Ltd, Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500302.

3
Parts
3 Link Toys
Seat Back Tube Pad
Front Tube
Lower Swing Arm Assembly
(with Restraint System)
Frame
2 Frame Tubes
Shown Actual Size
#6 x 1.9 cm Screws - 4
NOTE: Tighten and loosen all
screws with a Phillips screwdriver.
Do not over-tighten the screws.

4
Assembly
•Rotate the upper frame tube until it "snaps" into an upright
position, as shown.
IMPORTANT! Before assembly, inspect this product for
damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and instructions
if needed. Never substitute parts.
•Position the front tube so that the rubber feet are flat on
the surface.
•While pressing the button on the lower frame tube, insert it
into an end of the front tube. Continue to insert the lower
frame tube into the front tube until you hear a "click".
•While pressing the button on the front tube, insert it into
the end of the lower frame tube. Continue to insert the
front tube into the lower frame tube until you hear
a "click".
Upper Frame Tube
Press Button
on Front Tube
Press Button on
Lower Frame Tube
Rubber Feet Down
1 2

5
Assembly
•Pull the front tube to be sure it is secure to each lower
frame tube.
•While pressing the buttons on the upper frame tubes,
insert them into the holes in the underside of the frame.
•Continue to insert the upper frame tubes into the frame
until you hear a "click" on both sides.
Lower Frame Tubes
Pull Front Tube
Press Button
on Upper
Frame Tube
Frame
3
4

6
Assembly
•Check to be sure the upper frame tubes are secure in the
frame. If you can remove the upper frame tubes from the
frame, you have not properly inserted the tubes into the
frame. Remove the upper frame tubes from the frame and
repeat Assembly step 4.
•Fit the lower swing arm assembly to the outer side of the
upper swing arms.
FrameUpper Frame
Tube
Upper Frame
Tube
Lower Swing Arm Assembly
(with Restraint System)
Upper Swing Arms
5 6

7
Assembly
•Position the seat back tube so that it curves toward the back
of the swing.
•While pressing the buttons on the seat back tube, fit the
seat back tube into the short tubes on the swing arms.
•Push the seat back tube until it “clicks” into place.
•Pull up on the seat back tube to be sure it is secure to the
swing arms.
Seat Back Tube
Buttons
Swing Arm Short Tubes
7
8
•Insert two #6 x 1.9 cm screws through the upper swing arm
and into the lower swing arm. Tighten the screws.
Shown Actual Size
#6 x 1.9 cm Screws - 4

10
8
Assembly
•From behind the seat, insert the waist belts into the slots in
the pad.
•Push to fasten the restraint system to the pad.
Assembly is now complete.
SlotSlot
Waist Belts
Fastener
•Fit the top pocket on the pad over the seat back tube .
•Lift the seat bottom tube and fit the lower pocket on the
pad over the seat bottom tube .
9
Pad Top Pocket
Seat Back Tube
Pad Lower Pocket
Seat Bottom Tube



9
Battery Installation
1.5V x 4
LR14
SHOWN ACTUAL SIZE
Hint: We recommend using alkaline
batteries for longer battery life.
•Locate the battery compartment door on the frame.
•Loosen the screws in the battery compartment door.
•Remove the battery compartment door and the battery
holder from the battery compartment.
•Open the battery holder.
•Insert four LR14 alkaline batteries as indicated inside the
battery holder.
•Close the battery holder.
•Align the ridge on the battery holder with the groove in the
battery compartment.
•Slide the battery holder back into the battery compartment.
•Replace the battery compartment door and tighten
the screws.
Battery Compartment Door
Battery Holder
Battery Compartment Door
Battery Holder
1
2
3
Battery Holder

Battery Safety Information
Batteries may leak fluids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
•Do not mix old and new batteries or batteries of different
types: alkaline, standard (carbon-zinc) or rechargeable
(nickel-cadmium).
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of non-use. Always
remove exhausted batteries from the product. Dispose of
batteries safely. Do not dispose of batteries in a fire.The
batteries may explode or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or equivalent type
as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the product
before charging.
•If removeable, rechargeable batteries are used, they are
only to be charged under adult supervision.
Set-Up & Use
WARNING
IMPORTANT! Before each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp
edges. DO NOT use if any parts are missing or broken.
Contact Mattel for replacement parts and
instructions if needed. Never substitute parts.
10
To prevent serious injury or death
from falls and being strangled in
the restraint system:
- Always use the restraint system.
- Not recommended for children
who can sit up by themselves
(6 months approximately, until
9 kg, 20 lbs).
• Never leave child unattended.
• It is dangerous to use this product
on an elevated surface.