Fisher-Price V4873 User manual

V4873
V4873
www.fisher-price.co.uk
www.fisher-price.co.uk
IMPORTANT!
KEEP FOR FUTURE
REFERENCE.

2
Consumer Information
IMPORTANT! Please keep these instructions for future reference.
• Please read these instructions before assembly and use of
this product.
• Adult assembly is required.
• Tool required for assembly: Phillips screwdriver (not included).
• Requires four “D” (LR20) alkaline batteries for operation
(not included).
• Weight Limit: 9 kg (20 lbs).
IMPORTANT! The maximum weight limit for this product is
9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs), but
is really active and appears to be able to climb out of the swing,
immediately discontinue its use.
• Product features and decoration may vary from the photograph.
WARNING
To prevent serious injury or death
from falls and being strangled in the
restraint system:
• Always use the restraint system.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/20 lbs).
• Never leave child unattended.
• It is dangerous to use this product
on an elevated surface.
IMPORTANT! Please remove all parts from the package and identify
them before assembly. Some parts may be packed in the pad.
Parts
2 Base Tubes
Seat Pad
Seat Frame
Toy Bar
2 Swing Frames
2 Swing Arms
#8 x 3 cm Screw – 4
Shown Actual Size
Note: Tighten or loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
Fastener
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2010 Mattel, Inc. All Rights Reserved. ®and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA V4873a-0726
Great Britain:
Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303. www.service.mattel.com/uk.
Australia:
Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870,
Richmond, Victoria 3121 Australia. Consumer Advisory Service
1300 135 312.
New Zealand:
16-18 William Pickering Drive, Albany 1331, Auckland.
Asia:
Mattel East Asia Ltd, Room 1106, South Tower, World Finance
Centre, Harbour City, Tsimshatsui, HK, China.
Malaysia:
Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd. (993532-P)
Lot 13.5, 13th Floor, Menara Lien Hoe, Persiaran Tropicana
Golf Country Resort, 47410 PJ. Tel: [phone].
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.

3
CAUTION
This package contains small parts in
its unassembled state. Adult assembly
is required.
Assembly
2
1
• Pull both swing frame front and back legs apart until they “click”
into place.
• Fit the ends of one of the base tubes into the end of each swing
frame front leg.
Hint: The base tube is designed to fit one way. If it does not seem to
fit, turn it around and try again.
IMPORTANT! Before assembly and each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. DO NOT
use if any parts are missing or broken. Contact Fisher-Price®for
replacement parts and instructions if needed. Never substitute parts.
Swing Frame Front Leg Swing Frame Back Leg
Base Tube
3
• Fit the ends of the other base tube into the end of each swing
frame back leg.
Hint: The base tube is designed to fit one way. If it does not seem to
fit, turn it around and try again.
Base Tube
4
• Fit a swing arm into the socket in the swing housing, as shown.
Hint: The swing arms are designed to fit into the swing housing one
way. If the swing arm does not seem to fit, turn it around or try the
other housing.
• Repeat this procedure to assemble the other swing arm to the
swing housing.
Sockets
Swing Arms

4
Assembly
2 Screws
5
• Insert a screw into the hole in each swing housing.
Tighten the screws.
6
• Insert a screw into the hole in each seat hub. Tighten the screws.
• Fit the end of each swing arm into the sockets on the seat hubs,
as shown.
7
Seat Frame
2 Screws
• Fit the pad pockets onto the seat frame, as shown. Open the seat.
8

5
• Insert the waist belts into the lowest slots in the seat pad. Make
sure the belts are not twisted.
Assembly
9
Slot
Slot
Slot
Slot
Waist Belts
Smaller Baby
• Insert the ends of the shoulder belts through the lower slots in the
seat pad back.
• Slide each shoulder belt clip onto each waist belt buckle.
Shoulder Belts
Waist Belt
Lower Slots
Lower Slots
10
Larger Baby
• Insert the ends of the shoulder belts through the upper slots in the
seat pad back.
• Slide each shoulder belt clip onto each waist belt buckle.
11
Shoulder Belts
Waist Belt
Upper Slots
Upper Slots
• Insert and "snap" the toy bar into the socket in the swing housing.
Pull up on the toy bar up to be sure it is secure.
Hint: The toy bar is designed to fit one way. If it does not seem to fit,
turn it around and try again.
12
Toy Bar

6
1,5V x 4
“D” (LR20)
• Locate the battery compartment door on the frame.
• Loosen the screws in the battery compartment door.
• Remove the battery compartment door.
• Insert four “D” (LR20) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screws.
• If this product begins to operate erratically, you may need to
reset the electronics. Remove the batteries and replace them.
Note: Low battery power may cause product movement to slow
or product to turn off all together. If this should happen, replace the
batteries with four alkaline "D" (LR20) batteries.
Battery Installation
Battery Compartment Door
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Battery Safety Information
• Protect the environment by not disposing of this
product with household waste (2002/96/EC).
Check your local authority for recycling advice and
facilities (Europe only).
Seat Recline
• While pushing the button on each seat hub, lift or lower the
seat back.
WARNING
To prevent serious injury or death
from falls and being strangled in the
restraint system:
• Always use the restraint system.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 Kg/20 lbs).
• Never leave child unattended.
• It is dangerous to use this product
on an elevated surface.

7
1
Securing Your Child
• Place your child in the seat. Position the restraint pad between
your child’s legs.
• Fasten the waist/shoulder belts to the crotch pad. Make sure you
hear a “click” on both sides.
• Check to be sure the restraint system is securely attached
by pulling it away from your child. The restraint should
remain attached.
IMPORTANT! The maximum weight limit for this product is
9 kg (20 lbs). If your child weighs less than 9 kg (20 lbs), but
is really active and appears to be able to climb out of the swing,
immediately discontinue its use.
2
• Tighten each waist/shoulder belt so that the restraint system
is snug against your child. Please refer to the next section for
instructions to tighten the waist/shoulder belt.
Restraint System
3
• To tighten the waist belts: Feed the anchored end of the belt up
through the buckle to form a loop A. Pull the free end of the belt B.
Repeat this procedure to tighten the other belt.
• To loosen the waist belts: Feed the free end of the belt up
through the buckle to form a loop A. Enlarge the loop by pulling
on the end of the loop toward the buckle. Pull the anchored end
of the belt to shorten the free end of the belt B. Repeat this
procedure to loosen the other belt.
Note: After adjusting the belts to fit your child, make sure you pull
on them to be sure they are securely fastened.
LOOSENTIGHTEN
Free End
Waist/
Shoulder
Belts
Free End
Anchored End Anchored End
4
LOOSENTIGHTEN
To tighten the shoulder belts:
• Hold the adjuster A and pull the front shoulder strap down B.
To loosen the shoulder belts:
• Slide the adjuster down.
Adjusters
Restraint
Pad

8
Swinging and Music
Music/Sound
Selection Switch
Swing Power/
Speed Switch
Sound Power/
Volume Switch
• Place your child in the seat and secure properly.
• Slide the swing power/speed switch ON •.
• Give the seat a light push to start the swinging motion. Adjust the
swing power/speed switch to the desired swing motion setting.
Hints:
- After turning on power, this product may not swing unless there
is a child in the seat.
- As with most battery-powered swings, a heavier child will
reduce the amount of swinging motion on all settings. In most
cases, the low setting works best for a smaller child while the
high setting works best for a larger child.
- If the low setting provides too much swinging motion for your
child, try placing one end of a blanket underneath your child
and let the other end of the blanket drape down while swinging.
- If swinging stops while using a lower setting, try a higher
setting. Give the seat a light push to start the swinging
motion again.
• Slide the sound power/volume switch to ON with low volume ,
ON with high volume or OFF .
• Slide the music/sound selection switch to or .
• Be sure to turn this product off when not in use. Slide the swing
power/speed and sound power/volume switches OFF .
Storage
PRESS
PRESS
PRESS
PRESS
• While pushing both recline buttons, fold the seat.
1
2
PRESS
PRESS
• While pushing both frame buttons, push the back legs inward.
The pad is machine washable. Wash the pad separately in cold
water on the gentle cycle. Do not use bleach. Tumble dry separately
on low heat and remove promptly. The frame can be wiped clean
using a mild cleaning solution and a damp cloth. Do not immerse
the frame.
To remove the pad:
• Pull the restraint belts through the slots in the pad.
• Fold the seat and lift the pad off the seat frame.
To re-assemble the pad:
• Refer to assembly steps 8-11.
Care