Fisher-Price 79028 User manual

D
i
s
c
o
v
e
r
w
h
a
t
’
s
p
o
s
s
i
b
l
e
™
…
w
w
w
.
f
i
s
h
e
r
-
p
r
i
c
e
.
c
o
m
Open Top Take-Along Swing™
Model Numbers: 79028, B2479, B2106, B2107
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).
Requires four “C” (LR14) alkaline batteries for operation (not included).
Weight Limit: 20 lbs (9 kg).
IMPORTANT! The maximum weight limit for this product is 20 lbs. If your child
weighs less than 20 lbs., but is really active and appears to be able to climb
out of the swing, immediately discontinue its use.
Product features and decoration may vary from the picture above.

2
Warning and Caution
•To prevent serious injury or death from
falls and being strangled in the restraint
system:
-Always use the restraint system.
- Never use with an active child who
may be able to climb out of the seat.
• Never leave child unattended.
• Never use on any elevated surface.
WARNING
This package contains small parts
in its unassembled state.
Adult assembly is required.
CAUTION
Occasionally a consumer may experience a problem with one of our
products. If this should happen, please call us toll-free, rather than
return this product to the store. Usually, we can solve the problem
over the telephone or send you replacement parts.
Please call Fisher-Price® Consumer Relations, toll-free at 1-800-432-5437,
8 AM - 6 PM EST Monday through Friday. Hearing-impaired consumers
using TTY/TDD equipment, please call 1-800-382-7470.
Or, write to:
Fisher-Price® Consumer Relations
636 Girard Avenue
East Aurora, New York 14052
Consumer Information

Parts
3
Shown Actual Size
#6 x 3/4" Screw - 2
Seat Pad
2 Swing Frames
2 Base Tubes
Seat Frame

Assembly
1
4
IMPORTANT! Before assembly, inspect this product for damaged hardware,
loose joints, missing parts or sharp edges. DO NOT use if any parts are miss-
ing or broken. Contact Fisher-Price® for replacement parts and instructions
if needed. Never substitute parts.
•Slide the front and back legs on the swing frame outward until they “click”
into place.
•Repeat this procedure to open the other swing frame.
Swing Frame
Back Leg
Swing Frame
Front Leg

Assembly
5
•While pressing the buttons on the end of each front leg, insert the front
legs into the ends of one of the base tubes.
•Push the front legs down into the base tube until the buttons “click”
into place.
2
Base Tube
Press
Buttons
on Front Legs

Assembly
6
•While standing on the base tube, pull the front legs up.The front legs
should remain secured to the base tube. If you can remove the front legs,
you have not assembled them correctly to the base tube. Re-read and
repeat assembly step 2.
PULL UP
3
Base Tube

Assembly
7
4
Press
Buttons
on Back
Legs
•While pressing the buttons on the end of each back leg, insert the back
legs into the ends of the remaining base tube.
•Push the back legs down into the base tube until the buttons “click”
into place.
Base Tube

Assembly
8
5
Base Tube
•While standing on the base tube, pull the back legs up.The back legs
should remain secured to the base tube. If you can remove the back legs,
you have not assembled them correctly to the base tube. Re-read and
repeat assembly step 4.
PULL UP
PULL UP

•Position the seat frame so that the tubes are
upright, as shown.
•Fit the end of each frame arm into the socket in each seat hub.
Assembly
9
6
Hint: Note the location of the socket inside each seat hub.The ends of the
frame arms will be inserted into these sockets.
Seat Frame
Frame Arm
Frame
Arm
Frame Arm
Seat
Hubs
Socket
Seat
Hub
Socket

Assembly
10
7
•Insert a screw through the outside of each seat hub and into
each frame arm.Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Seat
Hub
Seat
Hub

Assembly
•Fit the pad upper pocket onto the seat
back tube, as shown.
•Insert the waist belts on the seat hubs
through the slots in the pad.
11
8
Seat Back
Tube
Waist
Belt
Waist Belts
Slot
Pad
Upper
Pocket

Assembly
•Fit the pad lower pocket onto the seat bottom tube, as shown.
Assembly is now complete.
12
9
Seat Bottom
Tube
Pad
Lower
Pocket

Battery Installation
13
Battery
Compartment
Door
•Locate the battery compartment door on the frame.
•Loosen the screws in the battery compartment door with a Phillips screwdriver.
•Remove the battery compartment door.
• Insert four "C" (LR14) alkaline batteries as indicated inside the battery
compartment.
•Replace the battery compartment door and tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Hint: We recommend using alkaline batteries for longer battery life.

Battery Safety Information
14
1.5V x 4
"C" (LR14)
SHOWN ACTUAL SIZE
Batteries may leak fluids that can cause a chemical burn injury or ruin
your product. To avoid battery leakage:
•Do not mix old and new batteries or batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable (nickel-cadmium).
•Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of batteries in a fire.The batteries may explode or leak.
•Never short-circuit the battery terminals.
•Use only batteries of the same or equivalent type, as recommended.
•Do not charge non-rechargeable batteries.
•Remove rechargeable batteries from the product before charging.
•If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.

15
Securing Your Child
•Place your child in the seat. Position the restraint pad between your
child’s legs.
•Fasten both waist belts to the buckles on each side of the restraint pad.
Make sure you hear a “click” on both sides.
•Check to be sure the restraint system is securely attached by pulling it away
from your child. The restraint should remain attached.
IMPORTANT! The maximum weight limit for this product is 20 lbs. If your
child weighs less than 20 lbs., but is really active and appears to be able to
clim out of the swing, immediately discontinue its use.
Waist
Belt
Buckle
Restraint Pad
•To prevent serious injury or death from
falls and being strangled in the restraint
system:
-Always use the restraint system.
- Never use with an active child who
may be able to climb out of the seat.
• Never leave child unattended.
• Never use on any elevated surface.
WARNING

Loosen
To tighten the belts:
•Feed the anchored end of the belt up through the buckle to form a loop .
•Pull the free end of the belt .
•Repeat this procedure to tighten the other belt.
To loosen the belts:
•Feed the free end of the belt up through the buckle to form a loop .
Enlarge the loop by pulling on the end of the loop toward the buckle.
•Pull the anchored end of the belt to shorten the free end of the belt .
•Repeat this procedure to loosen the other belt.
Please Note: After adjusting the belts to fit your child, make sure you pull on
them to be sure they are securely fastened.
B
B
Securing Your Child
Tighten
16
B
Anchored End
Free End
Anchored End
Free End
B

Starting the Swing
17
Power Switch
IMPORTANT! Before each use, inspect this product for damaged hardware,
loose joints, missing parts or sharp edges. DO NOT use if any parts are miss-
ing or broken. Contact Fisher-Price® for replacement parts and instructions
if needed. Never substitute parts.
•Slide the power switch to any of five speed settings.
•Give the seat a light push to start the swinging
motion. Adjust the power switch to the desired swing motion setting.
•If swinging stops while using a lower setting, try a higher setting. Give the
seat a light push to start the swinging motion again.
•Be sure to turn this product off when not in use. Slide the power switch to
the off setting .
Hint: As with most battery-powered swings, a heavier child will reduce the
amount of swinging motion on all settings. In most cases, the low
setting works best for a smaller child while the high setting works best
for a larger child.

18
Room-to-Room Portability
•To prevent serious injury or death from
falls and being strangled in the restraint
system, always use the restraint system.
•Never use on any elevated surface.
WARNING
•Make sure your child is properly secured in the swing seat.
•Grasp both handles, as shown, and lift.
•Carefully carry the swing to another room. Be sure to set the swing down
on a non-elevated, flat surface.

Storage
19
•Lift the seat bottom.
•Press the frame release buttons on the inside of the frames and push the
front legs inward.
•Press the frame release buttons on the inside of the frames and push the
back legs inward.
Lift
Press

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
Printed in China B2479b-0920
FCC Note (United States Only)
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits
are designed to provide reasonable protection against harmful interference
in a residential installation.This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user‘s authority to operate
the equipment.
Care
The pad is machine washable.Wash the pad separately in cold water on
the gentle cycle. Do not use bleach. Tumble dry separately on low heat and
remove promptly.The frame can be wiped clean using a mild cleaning solu-
tion and a damp cloth. Do not immerse the frame.
To remove the pad:
•Lift the footrest and remove the pad lower pocket
•Push the waist belts back through the pad.
•Slide the pad upper pocket off the seat back tube.
To re-assemble the pad:
•Refer to assembly steps 8 and 9.
For other countries, outside the United States:
Canada: call 1-800-567-7724, or write to: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2.
Great Britain: telephone [phone].
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag #870, Richmond,Victoria
3121 Australia. Consumer Advisory Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Asia: Mattel East Asia Ltd, Room 1106, South Tower, World Finance Centre, Harbour City,
Tsimshatsui, HK, China