Fisher-Price V9944 User manual

V9944
www.fisher-price.co.uk
IMPORTANT!
KEEP FOR FUTURE
REFERENCE.

2
To prevent serious injury or death from
falls and being strangled in the
restraint system:
• Always use the restraint system.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/20 lbs).
• Never leave child unattended.
• It is dangerous to use this product on
an elevated surface.
Consumer Information
IMPORTANT! Please keep these instructions for future reference.
• Please read these instructions before assembly and use of this product.
• Adult assembly is required.
• Tool required for assembly: Phillips screwdriver (not included).
• Requires four “C” (LR14) alkaline batteries for operation
(not included).
• Weight Limit: 9 kg (20 lbs).
IMPORTANT! The maximum weight limit for this product is 9 kg
(20 lbs). If your child weighs less than 9 kg (20 lbs), but is really active
and appears to be able to climb out of the swing, immediately
discontinue its use.
• Product features and decoration may vary from the picture.
WARNING
#6 x 2,5 cm Screw – 2
Shown Actual Size
IMPORTANT! Please remove all parts from the package and identify
them before assembly. Some parts may be packed in the pad.
Note: Tighten or loosen all screws with a Phillips screwdriver.
Do not over-tighten the screws.
2 Base Tubes
2 Swing Frames
Seat Pad
Seat Frame
Parts
Great Britain: Vanwall Business Park, Maidenhead SL6 4UB.
Helpline: 01628 500303. www.service.mattel.com/uk.
Australia: Mattel Australia Pty. Ltd., 658 Church Street, Locked Bag
#870, Richmond, Victoria 3121 Australia. Consumer Advisory
Service 1300 135 312.
New Zealand: 16-18 William Pickering Drive, Albany 1331, Auckland.
Asia: Mattel East Asia Ltd, Room 1106, South Tower, World Finance
Centre, Harbour City, Tsimshatsui, HK, China.
Malaysia: Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.
(993532-P) Lot 13.5, 13th Floor, Menara Lien Hoe,
Persiaran Tropicana Golf Country Resort, 47410 PJ.
Tel: [phone].
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
V9944pr-0726
PRINTED IN CHINA
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2010 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.

3
Swing Frame
Front Leg
Swing Frame
Back Leg
• Slide the front and back legs on the swing frame outward until they
“click” into place.
• Repeat this procedure to open the other swing frame.
Base Tube
Press Buttons
on Front Legs
• While pressing the buttons on the end of each front leg, insert
the front legs into the ends of one of the base tubes.
• Push the front legs down into the base tube until the buttons
“click” into place.
IMPORTANT! Before assembly and each use, inspect this product for
damaged hardware, loose joints, missing parts or sharp edges. DO NOT
use if any parts are missing or broken. Contact Fisher-Price®for
replacement parts and instructions if needed. Never substitute parts.
2
1
Assembly
This package contains small parts in its
unassembled state. Adult assembly is required.
CAUTION
• While standing on the base tube, pull the front legs up. The front legs
should remain secured to the base tube. If you can remove the front
legs, you have not assembled them correctly to the base tube. Re-read
and repeat assembly step 2.
PULL UP
PULL UP
3

4
Base Tube
Press Buttons
on Back Legs
• While pressing the buttons on the end of each back leg, insert the back
legs into the ends of the remaining base tube.
• Push the back legs down into the base tube until the buttons “click”
into place.
4
Assembly
• While standing on the base tube, pull the back legs up. The back legs
should remain secured to the base tube. If you can remove the back
legs, you have not assembled them correctly to the base tube. Re-read
and repeat assembly step 4.
PULL UP
PULL UP
5
6
• Position the seat frame so that the tubes are upright, as shown.
Hint: Note the location of the socket inside each seat hub. The ends of
the frame arms will be inserted into these sockets.
• Fit the end of each frame arm into the socket in each seat hub.
Frame Arm
Seat Frame
Socket
Seat Hub
Seat Hub
Seat Hub
• Insert a screw through the outside of each seat hub and into each
frame arm. Tighten the screws.
7

5
• Fit the pad upper pocket over the seat back tube.
• From behind the assembly, insert the waist belts through the slots in
the pad.
• Press to fasten the waist belt assembly to the pad.
Seat Back Tube
Pad Upper
Pocket
Waist Belts
8
Assembly
Slots
Slots
• Fit the pad lower pocket onto the seat bottom tube, as shown.
Pad Lower Pocket
Seat Bottom Tube
9
• Locate the battery compartment door on the frame.
• Loosen the screws in the battery compartment door.
• Remove the battery compartment door.
• Insert four “C” (LR14) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screws.
• If this product begins to operate erratically, you may need to reset the
electronics. Slide the power switch off and then back on.
Note: Low battery power may cause product movement to slow
or product to turn off all together. If this should happen, replace the
batteries with four alkaline "C" (LR14) batteries.
Battery Compartment Door
Battery Installation
1,5V x 4
“C” (LR14)
In exceptional circumstances, batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries of different types:
alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove
exhausted batteries from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be
charged under adult supervision.
Battery Safety Information
• Protect the environment by not disposing of this product with
household waste (2002/96/EC). Check your local authority
for recycling advice and facilities (Europe only).

6
Securing Your Child
To prevent serious injury or death from
falls and being strangled in the
restraint system:
• Always use the restraint system.
• Not recommended for children who
can sit up by themselves (6 months
approximately, until 9 kg/20 lbs.
• Never leave child unattended.
• It is dangerous to use this product on
an elevated surface.
WARNING
Waist Belt
Restraint Pad
Buckle
• Place your child in the seat. Position the restraint pad between your
child’s legs.
• Fasten both waist belts to the buckles on each side of the restraint pad.
Make sure you hear a “click” on both sides.
• Check to be sure the restraint system is securely attached by pulling
it away from your child. The restraint should remain attached.
IMPORTANT! The maximum weight limit for this product is 9 kg
(20 lbs). If your child weighs less than 9 kg (20 lbs), but is really active
and appears to be able to climb out of the swing, immediately
discontinue its use.
1
• Tighten each waist belt so that the restraint system is snug against
your child. Please refer to the next section for instructions to tighten
the waist belt.
Anchored End
Anchored End
To tighten the belts: Feed the anchored end of the belt up through the
buckle to form a loop A. Pull the free end of the belt B. Repeat this
procedure to tighten the other belt.
To loosen the belts: Feed the free end of the belt up through the
buckle to form a loop A. Enlarge the loop by pulling on the end of
the loop toward the buckle. Pull the anchored end of the belt to
shorten the free end of the belt B. Repeat this procedure to loosen
the other belt.
Note: After adjusting the belts to fit your child, make sure you pull on
them to be sure they are securely fastened.
Free End Free End
LOOSENTIGHTEN
Restraint System
2
3
A
B
A
B

7
Starting the Swing Room-to-Room Portability
• Place your child in the seat and secure properly.
• Slide the power switch ON •.
• Give the seat a light push to start the swinging motion. Adjust
the speed switch to the desired swing motion setting.
Hints:
- After turning on power, this product may not swing unless
there is a child in the seat.
- As with most battery-powered swings, a heavier child will
reduce the amount of swinging motion on all settings. In most
cases, the low setting works best for a smaller child while the
high setting works best for alarger child.
- If the low setting provides too much swinging motion for your
child, try placing one end of a blanket underneath your child
and let the other end of the blanket drape down while swinging.
- If swinging stops while using a lower setting, try a higher
setting. Give the seat a light push to start the swinging
motion again.
• Be sure to turn this product off when not in use. Slide the power
switch OFF .
Power Switch
Speed Switch
To prevent serious injury or death
from falls and being strangled in the
restraint system, never use on any
elevated surface.
• Make sure your child is properly secured in the swing seat.
• Grasp both handles, as shown, and lift.
• Carefully carry the swing to another room. Be sure to set the
swing down on a non-elevated, flat surface.
WARNING

8
• Lift the seat bottom.
LIFT
PRESS
PRESS
• Press the frame release buttons on the inside of the frames and push
the front legs inward.
• Press the frame release buttons on the inside of the frames and push
the back legs inward.
The pad is machine washable. Wash the pad separately in cold water
on the gentle cycle. Do not use bleach. Tumble dry separately on low
heat and remove promptly. The frame can be wiped clean using a mild
cleaning solution and a damp cloth. Do not immerse the frame.
To remove the pad:
• Lift the seat bottom and remove the pad lower pocket
• Push the waist belts back through the pad.
• Slide the pad upper pocket off the seat back tube.
To re-assemble the pad:
• Refer to assembly steps 8 and 9.
Storage Care
1
2