Fisher-Price BGT89 User manual

1
BGT89
fisher-price.com
Please keep this instruction sheet for future reference,
as it contains important information.
Adult assembly is required.
Requires three AA batteries (included).
Batteries included are for demonstration purposes only.
Tool required for battery replacement:
Phillips screwdriver (not included).
1
23
Lay & Play
Tummy time On-the-go
BEFORE FIRST TIME USE
Slide mode switch to
short play or long
play to turn off try-me
demonstration mode.

2
©2014 Mattel. All Rights Reserved.
PRINTED IN CHINA BGT89b-0920
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate
radio frequency energy and, if not installed
and used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
NOTE: Changes or modifications not
expressively approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre le fonctionnement du dispositif.
CO
N
S
UMER
ASS
I
S
T
A
N
C
E
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.

3
Battery Safety Information
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Replacement
1,5V x 3
AA (LR6)
• For longer life, use alkaline batteries.
• Locate the battery compartment door on the
music and lights toy.
• Loosen the screws in the battery
compartment door with a Phillips screwdriver
and remove the door.
• Remove the exhausted batteries and dispose
of them properly.
• Insert three AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• If the music and lights toy begins to operate
erratically, you may need to reset the
electronics. Slide the power/volume switch
off and back on.
• When sounds or lights become faint or stop,
it’s time for an adult to change the batteries.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.

4
6 Hanging Toys
Assembly
1
• Locate the hooks and loops underneath
the mat. The hook straps and the loops are
different colors. When properly assembled,
the hook strap color will match the loop color.
• While holding the end of an arch, carefully
unfasten the hook with the strap that does
not match the loop.
Mat
Arch Assembly
2
• Next, fasten the hook with strap that matches
the color of the loop on the other end of
the mat.
• Repeat this procedure to assemble the hooks
to the loops on the other side of the mat.
Arch Assembly with Mat
Assembled Parts
Music and
Lights Toy

5
Music and
Lights Toy
Assembly
1
2
3
4
• Slide and “snap” the music and lights toy
onto the arch assembly hub.
• To remove the music and lights toy and
use on-the-go: Slide the latch on the arch
assembly connector and lift to remove the
music and lights toy.
Electronic
Toy
Arch
Assembly
Hub
Storage and Care
Care
• The mat, parrot, monkey and zebra toys
are machine washable. Remove the arch
assembly from the mat. Machine wash
cold on the gentle cycle. Do not use bleach.
Tumble dry on low heat.
• The arch assembly, hard toys and music and
lights toy are surface washable only. Wipe
with a clean cloth dampened with a mild soap
and water solution. Do not immerse.
• Unfasten the hooks of one of the arches and
fold the arches together.
• Fasten the hooks to the loops on the other
end of the mat (on both sides).

6
WARNING
Grows with baby!
To prevent entanglement injury,
never place the gym in a crib or
playpen. Never add strings, ties or
other products to the gym.
• Slide the power/volume switch to ON with
low volume , ON with high volume or
OFF .
• Slide the music select switch to:
Instrumental Music
Sung Songs
• Slide the mode switch to:
Short Play - Tap or shake the music
and lights toy for a short tune and
dancing lights.
Long Play - Pull the toy on the music
and lights toy for up to 30 minutes of
music and a light show (only if you
select Instrumental Music ).
Power/Volume
Switch
Mode SwitchMusic Select
Switch
Hang the link on
each toy to any of
the loops around
the gym.